RESUMO

The Li+ ion mobility through the porous cathode is a critical aspect in the development of commercial Li-air batteries. The bulk transport properties of lithium salts in organic solvents are not reliable parameters for the design of this type of battery since confinement could significantly modify the transport properties, especially when pore diameters are below 10 nm. In this work, we studied the effect of the carbon mesostructure and surface charge on the diffusion of LiTf and LiTFSI salts dissolved in diglyme, typical electrolytes for lithium-air batteries. Interdiffusion coefficients of the salts were determined using a conductimetric method. NMR spectroscopy and relaxometry were used to explore the effect of the carbon structure and the surface charge density on the interaction between the electrolytes and the pore wall. We showed that carbon micro/mesoporous structure plays a critical role in the transport properties of the electrolyte, producing a decrease of up to 2-3 orders of magnitude in the salt interdiffusion coefficients when going from bulk solutions to pores below 4 nm in diameter. It was observed that for pores 25 nm in diameter, the reduction in the diffusion coefficient can be mainly ascribed to the porosity of the sample, giving tortuosity factors around 1. However, for smaller pore sizes (1-10 nm diameter) bigger tortuosity coefficients were observed and were related to strong ion-pore wall interactions. Moreover, it was noticed that the ratio between the diffusion coefficients of the two studied salts dissolved in diglyme, is different in bulk and under confinement, demonstrating that the interactions of the ions with the charged pore wall probably compete with the cation-anion interactions, affecting salt association under confinement.

RESUMO

Multiphase aqueous-organic systems where a bicontinuous phase is in equilibrium with an excess organic and aqueous phase find various applications in industry. These systems─also known as Winsor III─are complex not only for the different phases that develop therein but also because they are multicomponent systems. In this work, we explore for the first time the use of a benchtop low-field single-sided NMR to determine the species distribution in Winsor III systems. The proposed methodology provides information at macroscopic and microscopic levels. In particular, we show the use of single-sided NMR to determine the phases' dimensions and the species distribution in a polymer-based bicontinuous system. The phases' dimensions and limits can be resolved with micrometric precision and are indicative of the bicontinuous phase stability. The species distribution is determined by means of spatially resolved NMR relaxation and diffusion experiments. It was observed that the salinity of the aqueous phase also impacts the species distribution in the bicontinuous system. Experiments show that the additive and the polymer are mainly located in the bicontinuous phase. As the salinity of the aqueous phase increases, the amount of organic components in the bicontinuous phase decreases as a consequence of the species distribution in the system. This influences the total amount of recovered organic liquid from the organic phase. The information is obtained in a relatively fast experiment and is relevant to the system's possible applications, such as enhanced oil recovery (EOR). This methodology is not only circumscribed to its application in EOR but can also be applied to the study of any emulsion or microemulsion systems without sample size or geometry constraints.

RESUMO

Diffusion-relaxation correlation experiments in nuclear magnetic resonance are a powerful technique for the characterization of fluid dynamics in confined geometries or soft matter, in which relaxation may be either spin-spin (T2) or spin-lattice (T1). The general approach is to acquire a set of bidimensional data in which diffusion is codified by the evolution of the magnetization with either Hahn or stimulated echoes (STE) in the presence of a constant magnetic field gradient. While T2 is codified by a Carr-Purcell-Meiboom-Gil (CPMG) sequence, T1 is either encoded by saturation or inversion-recovery methods. In this work, we analyse the measurement time of diffusion-relaxation times in single-sided NMR and show that T1-D acquisition is always shorter than D-T2. Depending on the hardware characteristics, this time reduction can be up to an order of magnitude. We present analytical calculations and examples in model porous media saturated with water and in a dairy product.

Assuntos

RESUMO

The ability of single-shot NMR imaging methods to follow the time evolution of a velocity distribution within an object is strongly limited by the phase errors accumulated as velocity maps are acquired. In the particular case of Carr-Purcell based sequences combined with Echo Planar Imaging acquisition, phase accumulates through subsequent images, hampering the possibility to acquire several velocity maps, which would be useful to determine transient behavior. In this work, we propose the use of a rewinding velocity encoding module applied after the acquisition of each image during the CPMG echo train. In this way, the first velocity module imparts a velocity dependent phase prior to the image acquisition and the second pair cancels this phase out before the next refocusing radiofrequency pulse is applied. The performance and limits of this method are studied by acquiring 100 images of a co-rotating Couette cell over a period of 1.6 s as a function of the rotation speed. The method is applied to determine the kinematic viscosity of a water/alcohol mixture, which is a relevant topic in many physical, chemical and biological processes.

RESUMO

Two-dimension (2D) Nuclear Magnetic Resonance relaxometry experiments are a powerful tool extensively used to probe the interaction among different pore structures, mostly in inorganic systems. The analysis of the collected experimental data generally consists of a 2D numerical inversion of time-domain data where T2-T2 maps are generated. Through the years, different algorithms for the numerical inversion have been proposed. In this paper, two different algorithms for numerical inversion are tested and compared under different conditions of exchange dynamics; the method based on Butler-Reeds-Dawson (BRD) algorithm and the fast-iterative shrinkage-thresholding algorithm (FISTA) method. By constructing a theoretical model, the algorithms were tested for a two- and three-site porous media, varying the exchange rates parameters, the pore sizes and the signal to noise ratio. In order to test the methods under realistic experimental conditions, a challenging organic system was chosen. The molecular exchange rates of water confined in hierarchical porous polymeric networks were obtained, for a two- and three-site porous media. Data processed with the BRD method was found to be accurate only under certain conditions of the exchange parameters, while data processed with the FISTA method is precise for all the studied parameters, except when SNR conditions are extreme.

RESUMO

The fluid dynamics of a liquid|liquid system inside a four-electrode electrochemical cell were studied by velocimetry magnetic resonance imaging (MRI) and flow propagator measurements. To characterize this system fully, three different cell configurations operating at two rotational frequencies were analyzed. Quantitative information about the stability of the liquid|liquid interface and the dynamics of the organic phase were determined. The NMR spectroscopy results were in agreement with the electrochemical measurements performed by using the same experimental setup.

RESUMO

In the present work we studied the catalytic activity of E. coli ß-Gal confined in a nanoporous silicate matrix (Eß-Gal) at different times after the beginning of the sol-gel polymerization process. Enzyme kinetic experiments with two substrates (ONPG and PNPG) that differed in the rate-limiting steps of the reaction mechanism for their ß-Gal-catalyzed hydrolysis, measurements of transverse relaxation times (T2) of water protons through 1H-NMR, and scanning electron microscopy analysis of the gel nanostructure, were performed. In conjunction, results provided evidence that water availability is crucial for the modulation observed in the catalytic activity of ß-Gal as long as water participate in the rate limiting step of the reaction (only with ONPG). In this case, a biphasic rate vs. substrate concentration was obtained exhibiting one phase with catalytic rate constant (kcA), similar to that observed in solution, and another phase with a higher and aging-dependent catalytic rate constant (kcB). More structured water populations (lower T2) correlates with higher catalytic rate constants (kcB). The T2-kcB negative correlation observed along the aging of gels within the 15-days period assayed reinforces the coupling between water structure and the hydrolysis catalysis inside gels.

Assuntos

RESUMO

Hierarchical porous polymer systems are increasingly applied to catalysis, bioengineering, or separation technology because of the versatility provided by the connection of mesopores with percolating macroporous structures. Nuclear magnetic resonance (NMR) is a suitable technique for the study of such systems as it can detect signals stemming from the confined liquid and translate this information into pore size, molecular mobility, and liquid-surface interactions. We focus on the properties of water confined in macroporous polymers of ethylene glycol dimethacrylate and 2-hydroxyethyl methacrylate [poly(EGDMA-co-HEMA)] with different amounts of cross-linkers, in which a substantial variation of hydroxyl groups is achieved. As soft polymer scaffolds may swell upon saturation with determined liquids, the use of NMR is particularly important as it measures the system in its operational state. This study combines different NMR techniques to obtain information on surface interactions of water with hydrophilic polymer chains. A transition from a surface-induced relaxation in which relaxivity depends on the pore size to a regime where the organic pore surface strongly restricts water diffusion is observed. Surface affinities are defined through the molecular residence times near the network surface.

RESUMO

Evaporation kinetics of water confined in hierarchal polymeric porous media is studied by low field nuclear magnetic resonance (NMR). Systems synthesized with various degrees of cross-linker density render networks with similar pore sizes but different response when soaked with water. Polymeric networks with low percentage of cross-linker can undergo swelling, which affects the porosity as well as the drying kinetics. The drying process is monitored macroscopically by single-sided NMR, with spatial resolution of 100 µm, while microscopic information is obtained by measurements of spin-spin relaxation times (T2). Transition from a funicular to a pendular regime, where hydraulic connectivity is lost and the capillary flow cannot compensate for the surface evaporation, can be observed from inspection of the water content in different sample layers. Relaxation measurements indicate that even when the larger pore structures are depleted of water, capillary flow occurs through smaller voids.

RESUMO

In the traditional view of temperature-driven volume phase transitions in PNIPAM-based microgel solutions, a monotonic and sharp decrease in the particle size occurs upon heating the solution to above the volume phase transition temperature (VPTT). However, at sufficiently high microgel concentrations and under low salt conditions, our dynamic light scattering experiments reveal an unexpected non-monotonic evolution of the particle size when increasing the solution temperature. These findings show that poly(N-isopropylacrylamide-co-methacrylic acid) (P(NIPAM-co-MAA)) microgels swell upon heating the solution in the temperature range where NIPAM is water-soluble (i.e., below the VPPT). Further heating the microgel solution leads to microgel collapse as typically observed at temperatures above the VPTT. This novel behavior depends on the particle and salt concentration. We have observed the expected monotonic temperature-response of P(NIPAm-co-MAA) microgel solutions at low particle density and high salt concentration. To gain insights into the molecular origin of the unusual behavior of these microgel solutions, we have combined nuclear magnetic resonance studies and molecular-level theoretical calculations of the system. A delicate balance between inter-particle steric compressions and intra-microgel physical interactions and chemical equilibria determines the size of these microgels. Both steric compression, due to finite density, and hydrogen bond formation in the interior of the microgels favors a more compact particle. On the contrary, at the pH of the experiments the acid-base equilibrium constrains the polymer charge to increase, which favors particle swelling due to intra-microgel electrostatic repulsions. This interplay between physical interactions and chemical equilibria occurring at the nanometer length-scale determines the unusual thermal-induced swelling of P(NIPAM-co-MAA) microgels.