RESUMO

Oral candidiasis is an opportunistic infection that affects mainly individuals with weakened immune system. Devices used in the oral area to treat this condition include buccal films, which present advantages over both oral tablets and gels. Since candidiasis causes pain, burning, and itching, the purpose of this work was to develop buccal films loaded with both lidocaine (anesthetic) and miconazole nitrate (MN, antifungal) to treat this pathology topically. MN was loaded in microparticles based on different natural polymers, and then, these microparticles were loaded in hydroxypropyl methylcellulose-gelatin-based films containing lidocaine. All developed films showed adequate adhesiveness and thickness. DSC and XRD tests suggested that the drugs were in an amorphous state in the therapeutic systems. Microparticles based on chitosan-alginate showed the highest MN encapsulation. Among the films, those containing the mentioned microparticles presented the highest tensile strength and the lowest elongation at break, possibly due to the strong interactions between both polymers. These films allowed a fast release of lidocaine and a controlled release of MN. Due to the latter, these systems showed antifungal activity for 24 h. Therefore, the treatment of oropharyngeal candidiasis with these films could reduce the number of daily applications with respect to conventional treatments.

RESUMO

Vitamin E (VitE) is one of the most important antioxidants and plays a key role in decreasing the inflammatory effects of oxidative stress caused by recurrent doses of iron administration in anemia treatment. However, VitE is poorly soluble in aqueous environments. Here, VitE encapsulation into solid lipid nanoparticles (SLN) composed of myristil myristate to improve its bioavailability was proposed. A 99.9 ± 0.1% encapsulation efficiency with a drug/lipid ratio of 500 µg/mg and 478 higher VitE solubility was obtained. The antioxidant properties of VitE after encapsulation were maintained. SLN-VitE showed a 228.2 nm mean diameter with low polidispersitivity (0.335), and negative Z potential (ζ ≈ -9.0 mV). The SLN were well-dispersed, displayed spherical and homogeneous morphology by TEM. A controlled release of VitE from SLN was found. The XRD and FTIR analyses revealed the presence of a nanostructured architecture of SLN after VitE incorporation. We probed the safety of SLN-VitE after contact with three in vitro cell models: erythrocytes, lymphocytes and HepG2 cells. The cell viability in presence of SLN, SLN-VitE, and their combinations with iron was not affected. The comet assay demonstrated that the DNA damage caused by iron administration was decrease in presence of SLN-VitE.

Assuntos

RESUMO

Violacein (Viol) is a bacterial purple water-insoluble pigment synthesized by Chromobacterium violaceum and other microorganisms that display many beneficial therapeutic properties including anticancer activity. Viol was produced, purified in our laboratory, and encapsulated in a nanostructured lipid carrier (NLC). The NLC is composed of the solid lipid myristyl myristate, an oily lipid mixture composed of capric and caprylic acids, and the surfactant poloxamer P188. Dormant lipase from Rhizomucor miehei was incorporated into the NLC-Viol to develop an active release system. The NLC particle size determined by dynamic light scattering brings around 150 nm particle size and ζ≈ -9.0 mV with or without lipase, but the incorporation of lipase increase the PdI from 0.241 to 0.319 (≈32%). For scaffold development, a 2.5 hydroxypropyl methylcellulose/chitosan ratio was obtained after optimization of a composite for extrusion in a 3D-bioprinter developed and constructed in our laboratory. Final Viol encapsulation efficiency in the printings was over 90%. Kinetic release of the biodye at pH = 7.4 from the mesh containing NLC-lipase showed roughly 20% Viol fast release than without the enzyme. However, both Viol kinetic releases displayed similar profiles at pH = 5.0, where the lipase is inactive. The kinetic release of Viol from the NLC-matrices was modeled and the best correlation was found with the Korsmeyer-Peppas model (R2 = 0.95) with n < 0.5 suggesting a Fickian release of Viol from the matrices. Scanning Electron Microscope (SEM) images of the NLC-meshes showed significant differences before and after Viol's release. Also, the presence of lipase dramatically increased the gaps in the interchain mesh. XRD and Fourier Transform Infrared (FTIR) analyses of the NLC-meshes showed a decrease in the crystalline structure of the composites with the incorporation of the NLC, and the decrease of myristyl myristate in the mesh can be attributed to the lipase activity. TGA profiles of the NLC-meshes showed high thermal stability than the individual components. Cytotoxic studies in A549 and HCT-116 cancer cell lines revealed high anticancer activity of the matrix mediated by mucoadhesive chitosan, plus the biological synergistic activities of violacein and lipase.

RESUMO

Biopolymeric blends based on bacterial cellulose (BC) films modified with low molecular weight chitosan (Chi) were developed for controlled release of ciprofloxacin (Cip). Biophysical studies revealed a compatible and cooperative network between BC and Chi including deep structural changes in the BC matrix shown by spectroscopic and thermal analyses (SEM, roughness analysis, FTIR, XRD, TGA, mechanical properties and water vapor transmission rate). Incorporation of chitosan to BC matrix generated a thickening scaffold with high permeability to water vapor from 0.7 to 3.2 g mm/m2 h. Cip loaded onto the BC-Chi film showed a hyperbolic release profile with a 30% decrease in antibiotic release mediated by the presence of Chi. BC-Chi blend films containing Cip tested against Pseudomonas aeruginosa and Staphylococcus aureus showed a synergic effect of chitosan on Cip antimicrobial activity. Besides, in vitro studies revealed the lack of cytotoxicity of BC-Chi-Cip films in human fibroblasts.

Assuntos

RESUMO

The study of the noble metal magnetic hybrid nanoparticles is a really promising topic from both the scientific and the technological points of views, with applications in several fields. Iron oxide materials which are hybridized with noble metal nanoparticles (NPs) have attracted increasing interest among researchers because of their cooperative effects on combined magnetic, electronic, photonic, and catalytic activities. This review article contains a summary of magnetic noble metal/iron oxide nanoparticle systems potentially useful in practical biomedical applications. Among the applications, engineered devices for both medical diagnosis and treatments were considered. The preparation to produce different structures, as blends or core-shell structures, of several nanometric systems was also considered. Several characterization techniques available to describe the structure, morphology and different kinds of properties of hybrid nanoparticles are also included in this review.

RESUMO

Tioconazole (TCZ), a broad-spectrum antifungal agent, has significant activity against Candida albicans and other Candida species, and therefore, it is indicated for the topical treatment of superficial mycoses. The main goal of this work is to report an exhaustive identification and characterization procedure to improve and facilitate the online quality control and continuous process monitoring of TCZ in bulk material and loaded in two different dosage forms: ovules and nail lacquer. The methodologies were based on thermal (differential scanning calorimetry (DSC), melting point, and thermogravimetry (TG)), spectroscopic (ultraviolet (UV), Raman, near infrared (NIR), infrared spectroscopy coupled to attenuated total reflectance (FTIR-ATR), and nuclear magnetic resonance (NMR)), microscopic and X-ray diffraction (XRD). The TCZ bulk powder showed a high crystallinity, as observed by XRD, with a particles size distribution (3-95 µm) resolved by microscopic measurements. TCZ melting point (82.8 °C) and a degradation peak centered at 297.8 °C were obtained by DSC and DTG, respectively. An unambiguous structure elucidation of TCZ was obtained by mono- and two- dimensional 1H and 13C NMR spectral data analysis. The FTIR-ATR, Raman and NIR spectra of both the raw material and the commercial products were analyzed and their characteristic bands were tabulated. The best methods for TCZ identification in ovules were DSC, TG, XRD, NIR and Raman, while NIR and FTIR-ATR were the most appropriate techniques to analyze it in the nail lacquer. DSC, TG, DRX, Raman, FTIR-ATR and NIR spectroscopy are effective techniques to be used in online process analysis, because they do not require sample preparation, and they are considerably sensitive to analyze complex samples.

RESUMO

Vaginal candidiasis is considered a frequent opportunistic mucosal infection and the second most common cause of vaginitis after bacterial vaginosis. In this work, different vaginal films based on chitosan, hydroxypropyl methylcellulose and blends of these polymers containing tioconazole, were developed and thoroughly characterized to improve the conventional therapeutics of vaginal candidiasis. Mechanical properties, swelling, adhesiveness, morphology, antifungal activity, hemocompatibility and cytotoxicity were evaluated. The drug solid state in the films was analyzed by thermal and X-ray diffraction analysis. Films showed homogeneous surfaces and presented similar mechanical properties and adhesiveness. Time-kill studies displayed that films were more active than both tioconazole pure drug and traditional tioconazole ovule against Candida albicans, which is probably related to the fact that tioconazole is in amorphous state inside the films. Although all formulations proved to be hemocompatible, films based only on chitosan exhibited a certain degree of cytotoxicity and therefore they should be avoided. The system based on chitosan-hydroxypropyl methylcellulose with 40% PEG 400 as plasticizer presented fast antimicrobial activity as well as the lowest swelling. Additionally, this formulation did not produce substantial hemolytic and cytotoxic effects, indicating that films based on chitosan-hydroxypropyl methylcellulose could be a promising alternative dosage form for the treatment of vaginal candidiasis.

Assuntos

RESUMO

Two polysaccharides (PS), gum arabic (GA) and sodium alginate (SA), and whey protein concentrate (WPC) were used to design bio-based films at two ratios (RPS:WPC, 1:2 and 1:3). The effects of PS, RPS:WPC and WPC thermal treatment (unheated vs. aggregate) were determined on films characteristics. Film-forming dispersions were tested using different complementary techniques: UV-Vis spectroscopy, electrophoretic mobility, bulk rheology and confocal microscopy. PS exhibited weak associations with proteins. However, this behavior was more significative in SA/WPC systems. Rheological and optical characteristics of filmogenic suspensions were influenced by PS, RPS:WPC and WPC heat treatment. Apparent viscosity values for SA/WPC systems were 80-250 times higher than the ones obtained for GA/WPC systems. Furthermore, thickness, moisture absorption, contact angle and mechanical properties were also affected by the film design factors. GA/WPC-aggregates films showed lesser moisture absorption; however, they have higher surface polarity than those made with SA/WPC-aggregates. Moreover, SA/WPC-aggregates systems provided stronger films in comparison with the GA/WPC-aggregates ones. In addition, mechanical properties were also affected by RPS:WPC and WPC treatment. It was observed that denatured WPC and 1:3 RPS:WPC produced weaker mechanical features. Results provide useful information for the design of bio-based mixed films with tailor-made properties.

Assuntos

RESUMO

AIM: To develop and characterize the antitumor activity of poly(D,L-lactic-co-glycolic acid) nanoparticles loaded with hemostatic and anticancer drug desmopressin (dDAVP). MATERIALS & METHODS: After full physicochemical characterization, anticancer activity of dDAVP-loaded poly(D,L-lactic-co-glycolic acid) nanoparticles (NPdDAVP) was evaluated in vitro and in vivo on a highly aggressive breast cancer model. RESULTS: After efficiently loading desmopressin in poly(D,L-lactic-co-glycolic acid) matrix, NPdDAVP exhibited suitable physicochemical characteristics for biomedical applications. NPdDAVP displayed a potent cytostatic effect in vitro, inhibiting tumor cell proliferation and colony forming ability. Moreover, intravenous treatment using nanoparticulated-dDAVP inhibited tumor progression and prolonged survival in animals bearing rapidly-growing mammary tumors. CONCLUSION: Within the framework of promising dDAVP repurposing studies, these findings support further preclinical development of the NPdDAVP for the management of highly aggressive cancer.

Assuntos

RESUMO

Clay-based nanocomposites (nanoclays) are interesting systems to hold a wide type of active substances with a wide field of industrial applications. Bentonite-chitosan nanoclay was obtained via cationic exchange of natural bentonite (Bent) with an aqueous solution of chitosan (CS). Their physicochemical and morphological properties were discussed under the light of Fourier transform infrared spectroscopy, X-ray diffraction, thermogravimetric analysis, and scanning electron microscopy. Bent-CS characterization indicated that CS was intercalated in 10% (w/w). This polycationic polymer was oriented mostly in a monolayer arrangement, interacting by electrostatic forces between Bent sheets. The antimicrobial action of Bent-CS nanoclay was assayed onto phytopathogens, the bacterium model Pseudomonas syringe pv. tomato DC3000 ( Psy) and the necrotrophic fungus Fusarium solani f. sp. eumartii ( F. eumartii). In addition to demonstrating cell death on both microorganisms, Bent-CS exerted elicitor property on tomato plantlets. The biological actions of this natural nanomaterial might make it proper to be used in crops.

Assuntos