RESUMO

In anaerobic digestion (AD), the choice of inoculum type seems to be relevant for methane production for complex substrates, such as lignocellulosic material. Previous work demonstrated that the addition of fresh manure and ruminal fluid to anaerobic sludge improved methane productivity and kinetics of AD of crude sugarcane bagasse (CSB). Considering that the improvement of methane production could be a result of a more adapted microbial community, the present study performed the Next Generation Sequencing analysis to identify changes in the microbiome of anaerobic sludge inoculum, resulting from fresh manure and ruminal fluid addition. In comparison with AD performed only with anaerobic sludge inoculum (50:50, U), accumulated methane production was 15% higher with anaerobic sludge plus ruminal fluid inoculum (50:50, UR) and even higher (68%) with anaerobic sludge with fresh bovine manure inoculum (50:50, UFM), reaching the value of 143 NmLCH4.gVS-1. Clostridium species were highly abundant in all inocula, playing an important role during the hydrolysis and fermentation of CSB, and detoxifying potential inhibitors. Microbial composition also revealed the occurrence of Pseudomonas and Anaerobaculum at UFM inoculum that seem to have contributed to the higher methane production rate, mainly due to their hydrolytic and fermentative ability on lignocellulosic substrates. On the other hand, the presence of Alcaligenes might have had a negative effect on methane production due to their ability to perform methane oxidation.

Assuntos

RESUMO

The development of lignin-based admixtures (LBAs) for cement-based composites is an alternative to valorizing residual lignins generated in biorefineries and pulp and paper mills. Consequently, LBAs have become an emerging research domain in the past decade. This study examined the bibliographic data on LBAs through a scientometric analysis and in-depth qualitative discussion. For this purpose, 161 articles were selected for the scientometric approach. After analyzing the articles' abstracts, 37 papers on developing new LBAs were selected and critically reviewed. Significant publication sources, frequent keywords, influential scholars, and contributing countries in LBAs research were identified during the science mapping. The LBAs developed so far were classified as plasticizers, superplasticizers, set retarders, grinding aids, and air-entraining admixtures. The qualitative discussion revealed that most studies have focused on developing LBAs using Kraft lignins from pulp and paper mills. Thus, residual lignins from biorefineries need more attention since their valorization is a relevant strategy for emerging economies with high biomass availability. Most studies focused on production processes, chemical characterizations, and primary fresh-state analyses of LBA-containing cement-based composites. However, to better assess the feasibility of using different LBAs and encompass the multidisciplinarity of this subject, it is mandatory that future studies also evaluate hardened-sate properties. This holistic review offers a helpful reference point to early-stage researchers, industry professionals, and funding authorities on the research progress in LBAs. It also contributes to understanding the role of lignin in sustainable construction.

RESUMO

The fractionation of sugarcane bagasse (SB) by hydrothermal pretreatment (HP, autohydrolysis) followed by alkaline extraction (AE) and advanced oxidative pretreatment (AOP) for production of second-generation ethanol and biogas was investigated. The AOP of SB was optimized using a Doehlert design, varying the applied H2O2 load, liquid-to-solid ratio (LSR), and time. The responses evaluated were yield (Y), residual cellulose (RC), delignification (DE), and enzymatic conversion (EC). The AE of SB pretreated by HP led to 61.8% DE (using 0.2 mol L-1 NaOH). This high lignin removal enabled substantial savings of H2O2 in the AOP. The optimized AOP conditions led to 78% Y, 82.2% RC, 42.7% DE, and 88.9% EC (overall glucose yield of 60.9%). Fermentation of the enzymatic hydrolysate with Saccharomyces cerevisiae yielded 190.8 Lethanol tonSB-1. Biogas production by anaerobic digestion of residual liquid streams of the pretreatment steps yielded 27.46 NLCH4 kgSB-1. An energy balance was estimated for the SB fractionation.

Assuntos

RESUMO

In this study the anaerobic co-digestion (AcD) of sugarcane biorefinery by-products, i.e. hemicelluloses hydrolysate (HH) (obtained by hydrothermal pretreatment of sugarcane bagasse), vinasse, yeast extract (YE) and sugarcane bagasse fly ashes (SBFA), was optimized by means of biochemical methane potential experiments. The best experimental conditions of AcD (25-75% HH-to-vinasse mixture ratio; 1.0 g L-1 YE; 15 g L-1 SBFA and 100-0% HH-to-Vinasse; 1.5 g L-1 YE; 45 g L-1 SBFA) led to the production of 0.279 and 0.267 Nm3 of CH4 per kg of chemical oxygen demand (COD) with an energy surplus of 0.43 and 0.34 MJ kg SB-1, respectively. Adsorption experiments using SBFA were carried out and showed this residue could adsorb up to 61.71 and 17.32 mg g-1 of 5-hydroxymethyl-2-furfuraldehyde and 2-furfuraldehyde, thereby reducing toxicity and improving biogas production.

Assuntos

RESUMO

Ozone pretreatment of coffee husks (CH) was evaluated to generate hydrolysates for biogas production and to preserve cellulose of the solid phase for 2G ethanol production. Pretreatment variables included liquid-to-solid ratio (LSR), pH and specific applied ozone load (SAOL). Considering single-stage anaerobic digestion (AD), the highest methane production (36 NmL CH4/g CH) was achieved with the hydrolysate generated in the experiment using LSR 10 mL/g, pH 11 and SAOL 18.5 mg O3/g CH, leading to 0.064 kJ/g CH energy recovery. Due to the presence of toxic compounds in the hydrolysate, the addition of powdered activated carbon (4 g/L) to the reactor enhanced biogas production, leading to 86 NmL CH4/g CH yield and 0.58 kJ/g CH energy recovery. When two-stage AD was applied, methane production resulted in 49 NmL CH4/g CH, with additional 19 NmL H2/g CH production, resulting in a net 0.26 kJ/g CH energy recovery.

Assuntos

RESUMO

Linear alkylbenzene sulfonates (LAS) are synthetic anionic surfactants that are extensively used in many industries. As a result, large volumes of effluents containing high levels of these compounds are discharged into water bodies, causing risks to aquatic flora and fauna. Then, there is a need for environmentally safe and economically viable technologies for the removal of LAS from aqueous matrices. The present work evaluates the use of aqueous two-phase systems (ATPS) composed of PEG and sulfate salts for this purpose, considering the effects of tie line length (TLL), molar mass of polymer, and type of cation-forming salt on the partitioning behavior of LAS. All the LAS partition coefficient (KLAS) values were greater than unity, and the LAS extraction efficiencies (%ELAS) were higher than 97%. The system consisting of PEG 1500 + (NH4)2SO4 + H2O provided the highest KLAS (1083.34) and %ELAS (99.9%), indicating that the method provided good extraction of LAS to the top phase. This system was applied using a real effluent sample in laboratory-scale experiments as well as in bench-scale batch trials. The results obtained at the laboratory scale showed %ELAS values greater than 98%, while the best KLAS value obtained in the batch experiments was 8.50 (±1.75) (%ELAS = 78.17%). These values demonstrated the potential of ATPS for the removal of LAS from industrial effluents.

Assuntos

RESUMO

In the context of a sugarcane biorefinery, sugarcane bagasse produced may be pretreated generating a solid and liquid fraction. The solid fraction may be used for 2G bioethanol production, while the liquid fraction may be used to produce biogas through anaerobic digestion. The aim of this study consisted in evaluating the anaerobic digestion performance of hemicellulose hydrolysate produced after hydrothermal pretreatment of sugarcane bagasse. For this, hydrothermal pretreatment was assessed in a continuous upflow anaerobic sludge blanket (UASB) reactor operated at a hydraulic retention time (HRT) of 18.4h. Process performance was investigated by varying the dilution of sugarcane bagasse hydrolysate with a solution containing xylose and the inlet organic loading rate (OLR). Experimental data showed that an increase in the proportion of hydrolysate in the feed resulted in better process performance for steps using 50% and 100% of real substrate. The best performance condition was achieved when increasing the organic loading rate (OLR) from 1.2 to 2.4gCOD/L·d, with an organic matter removal of 85.7%. During this period, the methane yield estimated by the COD removal would be 270LCH4/kg COD. Nonetheless, when further increasing the OLR to 4.8gCOD/L·d, the COD removal decreased to 74%, together with an increase in effluent concentrations of VFA (0.80gCOD/L) and furans (115.3mg/L), which might have inhibited the process performance. On the whole, the results showed that anaerobic digestion of sugarcane bagasse hydrolysate was feasible and may improve the net energy generation in a bioethanol plant, while enabling utilization of the surplus sugarcane bagasse in a sustainable manner.

Assuntos

RESUMO

The present paper has focused on the potential application of multiwalled carbon nanotube for the development of a new, simple and highly selective electrochemical method for simultaneous Zn (II), Cd (II) and Pb (II) monitoring in water samples (lake and effluent waters), by using potentiometric stripping analysis (PSA). The electrochemical method is based on simultaneous preconcentration/reduction of metal ions onto a multiwall carbon nanotube electrode at -1.3V (versus Ag/AgCl(sat)) in 0.3 mol L(-1) acetate solution containing 15 mg L(-1) Hg (II) ions during 180s, followed by subsequent chemical stripping. The analytical curve for all analytes covered the linear range varying from 58.4 up to 646.2 microg L(-1) with correlation coefficients higher than 0.981. The limits of detection for Zn (II), Cd (II) and Pb (II) were found to be 28.0, 8.4 and 6.6 microg L(-1), while the relative standard deviation (RSD) at 352 microg L(-1) was 5.6, 7.1 and 5.6% (n=5), respectively. The behavior of the simultaneous determination in the presence of following ions Co (II), Cr (III) and Cu (II) was affected by using the analyte:interferent ratio 1:10. Therefore, by using standard addition method, Zn (II), Cd (II) and Pb (II) ions in lake and effluent water samples were determined after the spiking procedure and the results were successfully compared with those obtained by atomic absorption spectrometry (AAS). The obtained results suggest that the proposed method can be applied as a simple and efficient alternative for the simultaneous monitoring of heavy metals in water samples, according to those established requirements from environmental organizations. In addition, this method demonstrates the powerful application of carbon nanotubes in the field of potentiometric stripping analysis.

Assuntos