RESUMO
Protein-based foods based on sweet lupine are gaining the attention of industry and consumers on account of their being one of the legumes with the highest content of proteins (28-48%). Our objective was to study the thermal properties of two lupine flours (Misak and Rumbo) and the influence of different amounts of lupine flour (0, 10, 20 and 30%) incorporations on the hydration and rheological properties of dough and bread quality. The thermograms of both lupine flours showed three peaks at 77-78 °C, 88-89 °C and 104-105 °C, corresponding to 2S, 7S and 11S globulins, respectively. For Misak flour, higher energy was needed to denature proteins in contrast to Rumbo flour, which may be due to its higher protein amount (50.7% vs. 34.2%). The water absorption of dough with 10% lupine flour was lower than the control, while higher values were obtained for dough with 20% and 30% lupine flour. In contrast, the hardness and adhesiveness of the dough were higher with 10 and 20% lupine flour, but for 30%, these values were lower than the control. However, no differences were observed for G', Gâ³ and tan δ parameters between dough. In breads, the protein content increased ~46% with the maximum level of lupine flour, from 7.27% in wheat bread to 13.55% in bread with 30% Rumbo flour. Analyzing texture parameters, the chewiness and firmness increased with incorporations of lupine flour with respect to the control sample while the elasticity decreased, and no differences were observed for specific volume. It can be concluded that breads of good technological quality and high protein content could be obtained by the inclusion of lupine flours in wheat flour. Therefore, our study highlights the great technological aptitude and the high nutritional value of lupine flours as ingredients for the breadmaking food industry.
RESUMO
Quinoa is an Andean grain, classified as pseudocereal and the exploitation of its nutritional profile is of great interest for the cereal-based industry. The germination of quinoa seeds (white and red royal) was tested at 20 °C for different times (0, 18, 24 and 48 h) to select the best conditions for improving the nutritional quality of their flours. Changes in proximal composition, total phenolic compounds, antioxidant activity, mineral content, unsaturated fatty acids and essential amino acids profiles of germinated quinoa seeds were determined. In addition, changes in structure and thermal properties of the starch and proteins as consequence of germination process were analyzed. In white quinoa, germination produced an increase in the content of lipids and total dietary fiber, at 48 h, the levels of linoleic and α-linolenic acids and antioxidant activity increase, while in red quinoa, the component that was mostly increased was total dietary fiber and, at 24 h, increased the levels of oleic and α-linolenic acids, essential amino acids (Lys, His and Met) and phenolic compounds; in addition, a decrease in the amount of sodium was detected. On the basis of the best nutritional composition, 48 h and 24 h of germination were selected for white and red quinoa seeds, respectively. Two protein bands were mostly observed at 66 kDa and 58 kDa, being in higher proportion in the sprouts. Changes in macrocomponents conformation and thermal properties were observed after germination. Germination was more positive in nutritional improvement of white quinoa, while the macromolecules (proteins and starch) of red quinoa presented greater structural changes. Therefore, germination of both quinoa seeds (48 h-white quinoa and 24 h-red quinoa) improves the nutritional value of flours producing the structural changes of proteins and starch necessary for obtaining high quality breads.
RESUMO
Bread is a highly consumed food whose nutritional value can be improved by adding an oat flour (Avena sativa L.-variety Bonaerense INTA Calen-Argentina) to a high-industrial quality wheat flour (Triticum aestivum L.). This cultivar of oat contains high amounts of ß-glucans, which act as a prebiotic fiber. Wheat flour was complemented with different amounts of oat flour (5, 15, and 25%). A contribution of hydrophilic components from oat flour was evident in the oat-wheat mixtures. At the same time, the high content of total dietary fiber led to changes in the rheological properties of the dough. Mixtures with a higher proportion of oats showed an increase in alveographic tenacity (stiffer dough), higher stability, and a lower softening degree in farinographic assays. The dough showed significant increases in hardness and gumminess, without significant changes in cohesiveness, i.e., no disruption to the gluten network was observed. Relaxation tests showed that the blends with a higher oat content yielded 10 times higher stress values compared to wheat dough. Analysis of the oat-wheat breads showed improvements in nutritional parameters, with slight decreases in the volume and crust color. The crumb showed significant increases in firmness and chewing strength as the amount of oats added increased. Nutritional parameters showed that lipids, dietary fiber, and ß-glucans were significantly increased by the addition of oats. Sensory analysis achieved high response rates with good-to-very good ratings on the hedonic scale set. Thus, the addition of oats did not generate rejection by the consumer and could be accepted by them. Breads with wheat and oats showed nutritional improvements with respect to wheat bread, since they have higher dietary fiber content, especially in ß-glucans, so they could be considered functional breads.