RESUMO

This study set out to develop a thermally compatible glass to be infiltrated into zirconia partially stabilized by yttrium oxide (5Y-PSZ), to characterize it, and to evaluate its structural reliability and mechanical behavior. 5Y-PSZ zirconia discs (N = 90), dimensions 1.5 mm × 15 mm were produced, polished with #600 alumina oxide and #1200 silicon carbide sandpaper in a polisher. Three groups of 5Y-PSZ discs were assigned (n = 30): Zctrl: as sintered zirconia, Zinf-comp: glass-infiltrated zirconia on the occlusal surface, and sintered, and Zinf-tens: glass-infiltrated zirconia on the cementing surface and sintered; for biaxial flexural strength testing (ISO 6872:2015). A gel was synthesized via the sol-gel method and applied to the ceramic surface. Mechanical assay data (MPa) were evaluated via Weibull analysis (α = 5%) and specimens via X-Ray Diffractometry (XRD), Scanning Electron Microscopy (SEM), and fractographic analysis. The Zinf-tens group showed a characteristic strength of 824 MPa and m = 9.9; Zinf-comp 613 MPa and m = 10.2; Zctrl 534 MPa and m = 8; all groups differed statistically (σ0). However, they were similar in structural homogeneity (m). XRD showed 20-50 µm of infiltration, which means dissolution of part of the yttrium and reduction in the size of the cubic grains. In addition, the Zinf-tens group presented a failure origin from inside the material. The developed glass infiltrated into zirconia partially stabilized by yttrium oxide, increasing its characteristic strength and structural homogeneity by reducing surface defects and changing the failure mode.

Assuntos

RESUMO

PURPOSE/AIM: To evaluate the effect of different veneering liquids used for modeling on microhardness, fracture toughness and biaxial flexural strength of a glass-veneering ceramic. MATERIAL AND METHODS: The manufacturer recommended modeling liquid (ML), distilled water (DW), isopropyl alcohol (IA), 0.5% (P05), 1% (P1), and 2% (P2) polyethylene glycol solutions were mixed with feldspathic ceramic powder to form disc-shaped samples (n=20, 15 mm × 1.2 mm). After sintering, samples were mirror-polished and subjected to Vickers indentation (n=5) for measurement of microhardness and fracture toughness. The remaining 15 samples from each group were subjected to biaxial flexural strength. Data were subjected to one-way ANOVA and Weibull analysis. RESULTS: The microhardness was affected by veneering liquid (p=0.002): DW promoted higher microhardness values than ML and IA. Fracture toughness (p=0.301) and flexural strength (p=0.930) were not affected by the veneering liquid but Weibull parameters were affected. All groups presented surface pores under high magnification. CONCLUSION: Even though the use of DW led to higher values of surface microhardness than the ML, all obtained values are inside the range of enamel microhardness values reported in the literature. Such parameters may affect antagonist wear and should be reported in clinical trials.

Assuntos

RESUMO

In this work, ß-TCP (ß-tricalcium phosphate) bioresorbable scaffolds were prepared by the gel casting method. Then, they were impregnated with a 45S5 bioglass sol gel solution to improve biocompatibility and promote bioactivity and antimicrobial activity. The ß-TCP scaffolds had an apparent porosity of 72%, and after the incorporation of the bioglass, this porosity was maintained. The elements of the bioglass were incorporated into ß-TCP matrix and there was a partial transformation from the ß-TCP phase to the α-TCP (α-tricalcium phosphate) phase, besides the formation of bioactive calcium and sodium­calcium silicates. The scaffolds ß-TCP with 45S5 bioglass incorporated (ß-TCP/45S5) did not show a reduction in their values of mechanical strength and Weibull modulus, despite the partial transformation to the α-TCP phase. Bioactivity, cell viability, and antimicrobial activity improved significantly for the ß-TCP/45S5 scaffold comparing to the scaffold without the bioglass. The mineralization of carbonated hydroxyapatite was verified in Simulated Body Fluid (SBF). The cell viability, evaluated by the reduction of 3-[4,5-dimethylthiazol-2-yl]-2,5-diphenyltetrazolium bromide - MTT in MG63 cells, increased by 178%, and ß-TCP/45S5 scaffold also enhanced cell activity and osteoblast differentiation observed by means of total protein contend and alkaline phosphatase activity, respectively. The formation of growth inhibition zones was also observed in the disk diffusion assay for three tested microorganisms: Staphylococcus aureus, Escherichia coli and Candida albicans. To conclude, the vacuum impregnation method in 45S5 bioglass sol gel solution was effective in penetrating all the interconnected macroporosity of the scaffolds and covering the surface of the struts, which improved their biological properties in vitro, bioactivity and antibacterial activity, without reducing mechanical strength and porosity values. Thus, the ß-TCP/45S5 scaffolds are shown as potential candidates for use in tissue engineering, mainly in bone tissue regeneration and recovery.

Assuntos

RESUMO

BACKGROUND AND OBJECTIVE: Acute pancreatitis is one of the most common gastrointestinal conditions requiring hospitalization. Even though its presentation during pregnancy is uncommon, it is a medical challenge. Currently, no studies compare the clinical outcomes between pregnant patients with acute pancreatitis and nonpregnant patients with acute pancreatitis. Our aim was to compare the characteristics and clinical outcomes of pregnant and nonpregnant women with acute pancreatitis. METHODS: We conducted a retrospective study that included all patients admitted to our hospital with acute pancreatitis over a 10-year period. Demographics, general characteristics, and clinical outcomes were evaluated and compared between pregnant and nonpregnant women with acute pancreatitis, at a ratio of 1:5. RESULTS: Over 10 years, 27 pregnant patients with acute pancreatitis were treated. Etiology was biliary in 96% and hypertriglyceridemia was the cause in 3.4% (1 patient). The mean patient age was 26.2 years (range 15-36 years). The main cause of acute pancreatitis was biliary disease (96%). Patients in the study group were in their first, second, or third trimester of pregnancy, at 7.4%, 33.3%, and 59.3%, respectively. In the comparison of pregnant versus nonpregnant patients with acute pancreatitis, there were no differences in age, hospital stay (7.37 vs. 10.8, P=.814), severity (severe 3.7% vs. 16.7%, P=.79), local complications (0% vs. 1.9%, P=.476), or mortality (0% vs. 1.9%, P=.476). CONCLUSIONS: The clinical evolution of both groups with biliary acute pancreatitis was similar, with low morbidity and mortality.

Assuntos

RESUMO

Mainstream among topological insulators, GaSb/InAs quantum wells present a broken gap alignment for the energy bands which supports the quantum spin Hall insulator phase and forms an important building block in the search of exotic states of matter. Such structures allow the band-gap inversion with electrons and holes confined in adjacent layers, providing a fertile ground to tune the corresponding topological properties. Using a full 3D eight-band [Formula: see text] method we investigate the inverted band structure of GaSb/InAs/GaSb and InAs/GaSb/InAs multilayers and the behavior of the helical edge states, under the influence of an electric field applied along the growth direction. By tuning the electric field modulus, we induce the change of the energy levels of both conduction and valence bands, resulting in a quantum spin Hall insulator phase where the helical edge states are predominantly confined in the GaSb layer. In particular, we found that InAs/GaSb/InAs has a large hybridization gap of about [Formula: see text] and, therefore, are promising to observe massless Dirac fermions with a large Fermi velocity. Our comprehensive characterization of GaSb/InAs multilayers creates a basis platform upon which further optimization of III-V heterostructures can be contrasted.

RESUMO

Novel silica-based infiltrations on the surface of zirconia have the potential to improve their bondability, allowing for the etching/silane adhesive bonding technique. Nonetheless, adhesively bonded joints are subject to mixed tensile and shear stresses when the restoration is in occlusal service. Thus, we aimed to investigate the effect of 2 novel silica-based infiltrations on the interfacial toughness of adhesively bonded zirconia using the Brazil nut method, which allows for controlled types of stresses to be applied at the interfaces. In total, 150 3Y-TZP (In-Ceram YZ; Vita) Brazil nuts were machined and randomly assigned to 3 groups: C, control (air abraded); SG, sol-gel silica infiltration; and GI, glass infiltration. SG specimens were immersed twice in silicic acid for 20 min and dried (100°C, 1 h). GI specimens were presintered (1,400°C, 1 h) before a glass powder slurry was applied to the intaglio surface. All specimens were then sintered (1,530°C, 2 h). Following adhesive bonding (Panavia F 2.0, Kuraray) and water storage (37°C) for 10 d, the Brazil nuts were subdivided into groups baseline and aged (40,000 thermal cycles between 5°C and 55°C, with a dwell time of 30 s). The Brazil nuts were subjected to axial-loading tests using various inclinations (precrack angle with load direction): Θ = 0°, 5°, 10°, 15°, or 25°, which define the stress type at the interface, from pure tension (0°) to increasing levels of shear. Under pure tension (0°), GI yielded superior interfacial fracture energy, SG and C were similar, and aging had no effect. Under predominantly shear stresses (25°), aging significantly decreased interfacial fracture energy of C and SG, while GI remained stable and was superior. The glass infiltration of the zirconia intaglio surface increases its adhesive bonding interfacial toughness. The sol-gel silica infiltration method requires improvement to obtain a homogeneous surface infiltration and an enhanced bond strength.

Assuntos

RESUMO

Due to the nutritional content and commercial value of its seeds, Bertholletia excelsa is one of the most important species exploited in the Amazon region. The species is hermaphroditic, insect pollinated, and its seeds are dispersed by barochory and animals. Because the fruit set is dependent on natural pollinator activity, gene flow plays a key role in fruit production. However, to date, there have been no studies on pollen and seed flow in natural populations of B. excelsa. Herein, we used microsatellite loci and parentage analysis to investigate the spatial genetic structure (SGS), realized pollen and seed dispersal, and effective pollen dispersal for two B. excelsa populations in the Brazilian Amazon forest. Two plots were established in natural forests from which adults, juveniles, and seeds were sampled. Realized and effective pollen flow was greater than realized seed flow. The distance of realized pollen dispersal ranged from 36 to 2060 m, and the distance of realized seed dispersal ranged from 30 to 1742 m. Both pollen and seeds showed a dispersal pattern of isolation by distance, indicating a high frequency of mating among near-neighbor trees and seed dispersal near to mother trees. Both populations present SGS up to 175 m, which can be explained by isolation by distance pollen and seed dispersal patterns. Our results suggested that fragmentation of these forest populations may result in a significant decrease in gene flow, due to the isolation by distance pollen and seed dispersal patterns.

Assuntos

Assuntos

Assuntos

RESUMO

The ant genus Linepithema is widely known, thanks to the pest species Linepithema humile (Mayr), which is easily mistaken for Linepithema micans (Forel) due to their morphological similarity. Like L. humile, L. micans is associated to the main grapevine pest in Brazil, Eurhizococcus brasiliensis (Wille), also known as ground pearl. Therefore, the present study uses mtDNA fragments to expand the knowledge of haplotype diversity and distribution of L. micans in the state of Rio Grande do Sul (Brazil), to understand the genetic differences of the populations identified in this study. We identified 15 haplotypes of L. micans spread across different localities. Twelve of these haplotypes were new for the species. The high haplotype diversity uncovered in Rio Grande do Sul (Brazil) for this species was predictable, as L. micans is in its native environment. Additional studies that take gene flow into account may reveal interesting aspects of diversity in these populations.

Assuntos