RESUMO

In this work, gold NPs were prepared by the Turkevich method, and their interaction with HPV and cancerous cervical tissues were studied by scanning electron microscopy, energy-dispersive x-ray spectroscopy, confocal and multiphoton microscopy and SERS. The SEM images confirmed the presence and localization of the gold NPs inside of the two kinds of tissues. The light absorption of the gold NPs was at 520 nm. However, it was possible to obtain two-photon imaging (red emission region) of the gold NPs inside of the tissue, exciting the samples at 900 nm, observing the morphology of the tissues. The infrared absorption was probably due to the aggregation of gold NPs inside the tissues. Therefore, through the interaction of gold nanoparticles with the HPV and cancerous cervical tissues, a surface enhanced Raman spectroscopy (SERS) was obtained. As preliminary studies, having an average of 1000 Raman spectra per tissue, SERS signals showed changes between the HPV-infected and the carcinogenic tissues; these spectral signatures occurred mainly in the DNA bands, potentially offering a tool for the rapid screening of cancer.

Assuntos

RESUMO

Photodynamic and immune therapies are innovative medical strategies against cancer, and their integration with upconversion nanoparticles (UCNPs) can improve the diagnosis and treatment of the disease. The UCNPs convert the deep penetrating near-infrared (NIR) light into higher energy emissions, allowing the imaging and detection of malignant cells and the simultaneous energy transfer for activation of the photosensitizers. In this work, the UCNPs were coated with a photocatalytic TiO2/ZrO2 shell and an increase of oxygen defects (VO) was observed as a result of the partial substitution of Ti4+ by Zr4+ ions in the crystalline lattice of TiO2. Such defects act as trapping states improving charge separation and then reducing the recombination rate of the electron-hole pairs (e-/h+) generated upon resonant energy transfer from the donor (UCNPs) to acceptors (shell). The overall results are the enhancement of both ROS production and the emission band centered at 801 nm which is useful for tracking cells at the deep tissue level. However, an excess of those defects produces deleterious effects on both processes as a result of charge migration. The specificity against HER2 positive breast cancer was provided by bioconjugation with the monoclonal antibody trastuzumab. After administration of the synthesized NaYF4:Yb,Tm@TiO2/ZrO2-trastuzumab theranostic nanocomplex doped with an optimal ZrO2 molar concentration (25%) and subsequent exposure to 975 nm light (0.71 W cm-2) during 5 minutes, HER2-positive SKBr3 breast cancer cells were suppressed with 88% drop of the cell viability, 28% higher than UCNPs decorated with a pure TiO2 shell.

Assuntos

RESUMO

Surface-enhanced Raman spectroscopy (SERS) has recently emerged as an innovative tool for therapeutic-drug monitoring (TDM), making it an ideal candidate for personalized treatment. Herein, we report a layer-by-layer (LbL) approach for the fabrication of a highly reproducible hybrid SERS substrate based on graphene oxide (GO)-supported l-cysteine-functionalized starlike gold nanoparticles (SAuNPs). These designed substrates were utilized for TDM of paclitaxel and cyclophosphamide in blood serum. The SAuNPs' efficient binding at the edges of GO creates a better SERS hotspot with enhanced Raman sensitivity because of the spacing of ∼2.28 nm between the SAuNPs. In addition, the hierarchically modified substrate with a self-assembled monolayer of zwitterionic amino acid l-cysteines acts like a brush layer to prevent SERS-hotspot blockages and fouling by blood-serum proteins. The antifouling nature of the substrate was determined quantitatively by a bichinchonic acid assay using bovine-serum albumin (BSA) as a protein model on the l-cysteine SAuNPs@GO hybrid substrate (the test) and a cysteamine SAuNPs@GO substrate (the control). The l-cysteine SAuNPs@GO hybrid exhibited 80.57% lower BSA fouling compared with that of the cysteamine SAuNPs@GO substrate. The SERS spectra were acquired within 20 s, with detection limits of 1.5 × 10-8 M for paclitaxel and 5 × 10-9 M for cyclophosphamide in blood serum. Such sensitivities are 4 times and 1 order of magnitude higher than the currently available sophisticated analytical techniques, which involve high costs with each analysis.

Assuntos

RESUMO

We for the first time report the incorporation of cobalt into a mesoporous TiO2 electrode for application in perovskite solar cells (PSCs). The Co-doped PSC exhibits excellent optoelectronic properties; we explain the improvements by passivation of electronic trap or sub-band-gap states arising due to the oxygen vacancies in pristine TiO2, enabling faster electron transport and collection. A simple postannealing treatment is used to prepare the cobalt-doped mesoporous electrode; UV-visible spectroscopy, X-ray photoemission spectroscopy, space charge-limited current, photoluminescence, and electrochemical impedance measurements confirm the incorporation of cobalt, enhanced conductivity, and the passivation effect induced in the TiO2. An optimized doping concentration of 0.3 mol % results in the maximum power conversion efficiency of 18.16%, 21.7% higher than that of a similar cell with an undoped TiO2 electrode. Also, the device shows negligible hysteresis and higher stability, retaining 80.54% of the initial efficiency after 200 h.

RESUMO

The performance of perovskite solar cell (PSC) is highly sensitive to deposition conditions, the substrate, humidity, and the efficiency of solvent extraction. However, the physical mechanism involved in the observed changes of efficiency with different deposition conditions has not been elucidated yet. In this work, PSCs were fabricated by the antisolvent deposition (AD) and recently proposed air-extraction antisolvent (AAD) process. Impedance analysis and J-V curve fitting were used to analyze the photogeneration, charge transportation, recombination, and leakage properties of PSCs. It can be elucidated that the improvement in morphology of perovskite film promoted by AAD method leads to increase in light absorption, reduction in recombination sites, and interstitial defects, thus enhancing the short-circuit current density, open-circuit voltage, and fill factor. This study will open up doors for further improvement of device and help in understanding its physical mechanism and its relation to the deposition methods.

RESUMO

In the present work, we report a dry-based application technique of Au/SiO2 clouds in powder for rapid ex vivo adenocarcinoma diagnosis through surface-enhanced Raman scattering (SERS); using low laser power and an integration time of one second. Several characteristic Raman peaks frequently used for the diagnosis of breast adenocarcinoma in the range of the amide III are successfully enhanced by breading the tissue with Au/SiO2 powder. The SERS activity of these Au/SiO2 powders is attributed to their rapid rehydration upon contact with the wet tissues, which promotes the formation of gold nanoparticle aggregates. The propensity of the Au/SiO2 cloud structures to adsorb biomolecules in the vicinity of the gold nanoparticle clusters promotes the necessary conditions for SERS detection. In addition, electron microscopy, together with elemental analysis, have been used to confirm the structure of the new Au/SiO2 cloud material and to investigate its distribution in breast tissues.

RESUMO

A multilayered semiconductor sensitizer structure composed of three differently sized CdSe quantum rods (QRs), labeled as Q530, Q575, Q590, were prepared and deposited on the surface of mesoporous TiO2 nanoparticles by electrophoretic deposition (EPD) for photovoltaic applications. By varying the arrangement of layers as well as the time of EPD, the photoconversion efficiency was improved from 2.0% with the single layer of CdSe QRs (TiO2/Q590/ZnS) to 2.9% for multilayers (TiO2/Q590Q575/ZnS). The optimal EPD time was shorter for the multilayered structures. The effect of CdS quantum dots (QDs) deposited by successive ionic layer adsorption and reaction (SILAR) was also investigated. The addition of CdS QDs resulted in the enhancement of efficiency to 4.1% for the configuration (TiO2/CdS/Q590Q575/ZnS), due to increased photocurrent and photovoltage. Based on detailed structural, optical, and photoelectrical studies, the increased photocurrent is attributed to broadened light absorption while the increased voltage is due to a shift in the relevant energy levels.

RESUMO

A Mueller-Stokes analysis is applied to pure bismuth thin film samples prepared by the laser ablation technique by using a polarimeter with a 632.8 nm continuum wavelength laser. The complex refractive index is determined in the range of 250-1100 nm. Results from the Mueller matrix show the high sensitivity of diattenuation and polarizance parameters as a function of the sample thickness and the incidence angle, except at the pseudo-Brewster angle, where they exhibit the same value. Results show that the knowledge of the polarimetric response, with appropriate incident polarization states, could be used to design photonic Bi-based devices for several applications. Polarization dependence is the result of changes on the surface morphology as a result of the small value of the skin depth.

RESUMO

Transparent BaTiO(3):Eu(3+) films were prepared via a sol-gel method and dip-coating technique, using barium acetate, titanium butoxide, and polyvinylpyrrolidone (PVP) as modifier viscosity. BaTiO(3):Eu(3+) films ~500 nm thick, crystallized after thermal treatment at 700 masculineC. The powders revealed spherical and rod shape morphology. The optical quality of films showed a predominant band at 615 nm under 250 nm excitation. A preliminary luminescent test provided the properties of the Eu(3+) doped BaTiO(3).

Assuntos