RESUMO

Sulfate radical-based advanced oxidation processes (SR-AOPs) are renowned for their exceptional capacity to degrade refractory organic pollutants due to their wide applicability, cost-effectiveness, and swift mineralization and oxidation rates. The primary sources of radicals in AOPs are persulfate (PS) and peroxymonosulfate (PMS) ions, sparking significant interest in their mechanistic and catalytic aspects. To develop a novel nanocatalyst for SR-AOPs, particularly for PMS activation, we synthesized carbon-coated FeCo nanoparticles (NPs) using solvothermal methods based on the polyol approach. Various synthesis conditions were investigated, and the NPs were thoroughly characterized regarding their structure, morphology, magnetic properties, and catalytic efficiency. The FeCo phase was primarily obtained at [OH-] / [Metal] = 26 and [Fe] / [Co] = 2 ratios. Moreover, as the [Fe]/[Co] ratio increased, the degree of xylose carbonization to form a carbon coating (hydrochar) on the NPs also increased. The NPs exhibited a spherical morphology with agglomerates of varying sizes. Vibrating-sample magnetometer analysis (VSM) indicated that a higher proportion of iron resulted in NPs with higher saturation magnetization (up to 167.8 emu g-1), attributed to a larger proportion of FeCo bcc phase in the nanocomposite. The best catalytic conditions for degrading 100 ppm Rhodamine B (RhB) included 0.05 g L-1 of NPs, 2 mM PMS, pH 7.0, and a 20-min reaction at 25 °C. Notably, singlet oxygen was the predominant specie formed in the experiments in the SR-AOP, followed by sulfate and hydroxyl radicals. The catalyst could be reused for up to five cycles, retaining over 98% RhB degradation, albeit with increased metal leaching. Even in the first use, dissolved Fe and Co concentrations were 0.8 ± 0.3 and 4.0 ± 0.5 mg L-1, respectively. The FeCo catalyst proved to be effective in dye degradation and offers the potential for further refinement to minimize Co2+ leaching.

Assuntos

RESUMO

The estrogen metabolite 2-methoxyestradiol (2ME) is a promissory anticancer drug mainly because of its pro-apoptotic properties in cancer cells. However, the therapeutic use of 2ME has been hampered due to its low solubility and bioavailability. Thus, it is necessary to find new ways of administration for 2ME. Zeolites are inorganic aluminosilicates with a porous structure and are considered good adsorbents and sieves in the pharmaceutical field. Here, mordenite-type zeolite nanoparticles were loaded with 2ME to assess its efficiency as a delivery system for prostate cancer treatment. The 2ME-loaded zeolite nanoparticles showed an irregular morphology with a mean hydrodynamic diameter of 250.9 ± 11.4 nm, polydispersity index of 0.36 ± 0.04, and a net negative surface charge of -34 ± 1.73 meV. Spectroscopy with UV-vis and Attenuated Total Reflectance Infrared Fourier-Transform was used to elucidate the interaction between the 2ME molecules and the zeolite framework showing the formation of a 2ME-zeolite conjugate in the nanocomposite. The studies of adsorption and liberation determined that zeolite nanoparticles incorporated 40% of 2ME while the liberation of 2ME reached 90% at pH 7.4 after 7 days. The 2ME-loaded zeolite nanoparticles also decreased the viability and increased the mRNA of the 2ME-target gene F-spondin, encoded by SPON1, in the human prostate cancer cell line LNCaP. Finally, the 2ME-loaded nanoparticles also decreased the viability of primary cultures from mouse prostate cancer. These results show the development of 2ME-loaded zeolite nanoparticles with physicochemical and biological properties compatible with anticancer activity on the human prostate and highlight that zeolite nanoparticles can be a good carrier system for 2ME.

Assuntos

Assuntos

RESUMO

A novel hybrid nanomaterial, nanoscale zero-valent iron (nZVI)-grafted imogolite nanotubes (Imo), was synthesized via a fast and straightforward chemical procedure. The as-obtained nanomaterial (Imo-nZVI) was characterized using transmission electron microscopy (TEM), electrophoretic mobility (EM), and vibrating sample magnetometry (VSM). The prepared Imo-nZVI was superparamagnetic at room temperature and could be easily separated by an external magnetic field. Sorption batch experiments were performed for single- and multicomponent systems and demonstrated that Hg2+ and Pb2+ could be quantitatively adsorbed at pH 3.0. For multicomponent systems, maximum adsorption capacities of 61.6 mg·g-1 and 76.9 mg·g-1 were obtained for Hg2+ and Pb2+ respectively. It was observed that the functional groups in Imo-nZVI interact preferentially with analytes according to the Misono softness parameter. The higher performance of Imo-nZVI compared with Imo and nZVI is related to the increased number of adsorption sites in the functionalized nanomaterial. The sorption equilibrium data obeyed the Langmuir model, while kinetic studies demonstrated that the sorption processes of Hg2+ and Pb2+ followed the pseudo-second-order model. This study suggests that the Imo-nZVI composite can be used as a promising sorbent to provide a simple and fast separation method to remove Hg and Pb ions from contaminated water.

Assuntos

RESUMO

Magnetic-field-accelerated photocatalytic degradation of the phenol red (PR) as a model organic pollutant was studied using rare-earth elements modified BiFeO3 (Bi1-xRxFeO3 (R = Ce, Tb; x = 0.0, 0.05, 0.10 and 0.15); BFO: RE) nanostructures. The nanostructures were prepared via the hydrothermal process and their morphological, structural, functional, optical and magnetic features were investigated in detail. The effect of magnetic fields (MFs) on photocatalysis were examined by applying the different MFs under visible light irradiation. The enhanced photodegradation efficiencies were achieved by increasing the MF up to 0.5T and reduced at 0.7T for the compositions x = 0.10 in both Ce and Tb substituted BFO. Further, mineralization efficiencies of PR, reproducibility of MF-assisted photocatalysis, stability and recyclability of BFO: RE nanostructures were also tested.

RESUMO

In this study, (1 - x) BFO-xCFO (CFO, x = 0.00, 0.05, 0.10 and 0.30) ceramics were synthesized by a solid-state reaction method; their compositions were driven by structural, microstructural, vibrational, electrical, magnetic properties; their enhanced magneto capacitance (MC) effect have also been carried out. Reitveld refinement studies of X-ray diffraction data shows composition-driven structural phase transformation from rhombohedral (R3c) to tetragonal (P4mm). Two phonon scattering Raman modes were observed for the higher wavenumber which supports the crystal structural transition in the BFO-CFO. Ferroelectric polarization shows that the polarization increased with increasing CFO concentration, which describes the changes of the polar symmetry of the crystal structure from rhombohedral (R3c) to tetragonal (P4mm). In Further, the maximum efficiency of energy density (η = 68.65%), reversible energy density of 0.138 J/cm3 and the strong magneto capacitance was observed in 0.9BFO-0.1CFO, which belongs to the morphotropic phase boundary (MPB) region near to the BiFeO3-rich region. The magnetic response analysis has shown, the saturation magnetization (Ms) values of 83 emu/gm and 139 emu/gm for pure CFO and 0.7BFO-0.3CFO composite, respectively, and their magnetic behaviours were also confirmed with Arrott-Belov-Kouvel (ABK) plot.

RESUMO

Natural polymer-based hybrid nanocomposites have been proposed as one of the most promising tools for biomedical applications, including disease treatment and diagnosis procedures. Xyloglucan nanocapsules can simultaneously load magnetic iron oxide nanoparticles and bioactive for a specific tissue, reducing the processes of degradation and metabolic inactivation of molecules with biological activity. In this work, magnetic nanocapsules of xyloglucan loaded with hydrophilic sulfated quercetin (MNXQ_SO3) were successfully synthesized by inverse miniemulsion process through interfacial polymerization. The polymeric shell formation of nanocapsules was evidenced by Fourier Transform Infrared spectroscopy and Transmission Electron Microscopy. The ferrofluid (Fe3O4@PAAS) incorporated into the xyloglucan nanocapsules was synthesized by hydrothermal method, using polyacrylic acid sodium salt as coating. Dynamic Light Scattering technique confirmed the nanomeric dimensions (202.3 nm) and the good colloidal stability (-40.2 mV) of MNXQ_SO3. The saturation magnetization analyses pointed out the superparamagnetic behavior of Fe3O4@PAAS (48 emu/g) and MNXQ_SO3 (4.2 emu/g). MNXQ_SO3 was able to modify the release profile of sulfated quercetin (67%) when compared to the free bioactive (100%), exhibiting a release profile compatible with the zero-order kinetic model. The results showed that the development of MNXQ_SO3 presents a new perspective for biomedical applications, including studies of targeted drug delivery.

Assuntos

RESUMO

Magnetic skyrmions are nontrivial spin textures that resist external perturbations, being promising candidates for the next-generation recording devices. Nevertheless, a major challenge in realizing skyrmion-based devices is the stabilization of ordered arrays of these spin textures under ambient conditions and zero applied field. Here, we demonstrate for the first time the formation and stabilization of magnetic skyrmions on the arrays of self-assembled hexagonal nanodomes taking advantage of the intrinsic properties of its curved geometry. Magnetic force microscopy images from the arrays of 100 nm nanodomes showed stable skyrmions at the zero field that are arranged following the topography of the nanostructure. Micromagnetic simulations are compared to the experiments to determine the correlation of the domain textures with the topography of the samples. We propose a simple method to nucleate and annihilate skyrmions, opening the possibility for an ultradense data storage based on the high stability and low energy consumption of the skyrmionic textures.

RESUMO

Nickel nanopillar arrays were electrodeposited onto silicon substrates using porous alumina membranes as a template. The characterization of the samples was done by scanning electron microscopy, X-ray diffraction, and alternating force gradient magnetometry. Ni nanostructures were directly grown on Si by galvanostatic and potentiostatic electrodeposition techniques in three remarkable charge transfer configurations. Differences in the growth mechanisms of the nanopillars were observed, depending on the deposition method. A high correlation between the height of the nanopillars and the charge synthesis was observed irrespective of the electrochemical technique. The magnetization measurements demonstrated a main dependence with the height of the nanopillars. The synthesis of Ni nanosystems with a controllable aspect ratio provides an effective way to produce well-ordered networks for wide scientific applications.

Assuntos

RESUMO

This work proposes the development of a starch-based drug carrier for fluoxetine (FLX) delivery and evaluate the improvement of the drug antibacterial activity. The starch nanocapsules were prepared via interfacial polyaddition reaction presenting a core-shell morphology, based on polyurethane linkage, with a particle size in the range 250-300 nm. Furthermore, FLX-loaded nanocapsules were evaluated regarding antibacterial potential against Staphylococcus aureus (ATCC® 6538P ™) and its clinical strains of methicillin-resistant. As expected, the FLX-loaded presented lower minimum inhibitory concentration (MIC) values, in the range of 190-95 µg mL-1, against all isolated microorganisms in comparison to FLX, 255 µg mL-1. According to results, the FLX-loaded starch nanocapsules have successfully improved drug antibacterial activity, generating promising perspectives on the field of the hydrophilic drug delivery systems.

Assuntos