RESUMO
The accelerated growth of cyanobacteria in water bodies is a global critical environmental issue caused by continuous discharges of effluents into the environment that are rich in phosphorus and nitrogen. So, cyanobacteria have found propitious conditions for proliferation, provoking significant ecological imbalances. Cyanobacteria produce cyanotoxins, which are harmful to life, and compounds like 2-methylisoborneol and geosmin that affect water's taste and odor. This study analyzed a long-term database of important environmental parameters from a tropical reservoir in São Paulo State, Brazil. The statistical methods of correlation matrices and principal component analysis were used. Data analysis revealed a significant relationship between cyanobacteria growth and high levels of phosphate and nitrogen. Furthermore, positive correlations were found among concentrations of biocidal elements like antimony, arsenic, and selenium related to cyanobacterial bloomings. These correlations can be attributed to agricultural wastewaters and/or possible algicide used to control these microorganisms.
Assuntos
Cianobactérias , Qualidade da Água , Brasil , Agricultura , NitrogênioRESUMO
Diclofenac (DCF) can cause several adverse effects in the environment and it should be removed from industrial pharmaceutical wastewaters. Advanced oxidation processes (AOPs) are promising methods for the DCF degradation. But, in many cases, AOPs require acidic pH. However, at this condition, DCF precipitates, which may hinder its oxidation. Thus, in this work, some AOP were studied for the DCF degradation, especially the photo-Fenton process, applying the experimental design technique (Doehlert matrix), operating without and with pH control (between 6.5 and 7.0). As independent variables, the initial ferrous ion concentration ([Fe2+]) and the molar addition rate of H2O2 (FH2O2) were evaluated. Empirical models were proposed and optimized conditions were determined without ([Fe2+] = 0.27 mmol L-1 and FH2O2 = 1.64 mmol min-1) and with pH control ([Fe2+] = 1.0 mmol L-1 and FH2O2 = 1.64 mmol L-1), with the following predicted mineralization percentages: 93% and 68%, respectively. So, photo-Fenton process without pH control presented the best performances. Furthermore, at this condition, iron concentration respects the limit value established by the Brazilian environmental legislation. That is, in this condition, additional processes, in order to remove iron ions, would not be necessary, that is very interesting for applications on an industrial scale.
Assuntos
Águas Residuárias , Poluentes Químicos da Água , Eliminação de Resíduos Líquidos/métodos , Diclofenaco , Peróxido de Hidrogênio/química , Poluentes Químicos da Água/química , Ferro/química , Íons , Oxirredução , Concentração de Íons de HidrogênioRESUMO
ABSTARCTThe antibiotic amoxicillin (AMX) is a semisynthetic aminopenicillin, classified as an ß-lactam antibiotic. This work aims to evaluate the AMX degradation (190 mg L-1), in aqueous medium, applying photo-Fenton ([TOC]0 = 100 mgC L-1; FH2O2 = 3.27 mmol min-1; [Fe2+] = 0.27 mmol L-1; pH = 3.0; T = 40°C) and acid hydrolysis processes. Along the experiments, samples were withdrawn and analyzed by a total organic carbon (TOC) analyzer and a liquid chromatography system coupled to diode array (HPLC-DAD) and mass spectrometry (HPLC-MS) detectors. The hydrolysis process proved to be less efficient, because AMX removals greater than 80% were observed only after 24 hours of reaction (pH 2). Conversely, the photo-Fenton process removed completely AMX in just 20 minutes, reaching 85% of TOC removal in 2 hours. Finally, the AMX aqueous solutions treated by the studied processes was also evaluated in respect of its toxicity to some microorganisms, applying two antimicrobial susceptibility tests: disk-diffusion and broth microdilution methods. It was observed that the AMX aqueous solutions, pretreated by the photo-Fenton process, for just 7.5 min of reaction time, did not inhibit the microorganisms growth. The obtained results show that the photo-Fenton process was able to degrade AMX, in a relatively short time, and that the generated degradation products did not inhibit the microorganisms growth, when compared to acid hydrolysis process. Thus, it was verified the potential application of the photo-Fenton system as a pretreatment step to conventional biological oxidation processes for the treatment of industrial wastewaters.