RESUMO
BACKGROUND: Microscopic inflammation and impairment of the esophageal epithelial barrier are considered relevant for perception of symptoms in patients with nonerosive reflux disease (NERD). In these patients, the receptor transient receptor potential vanilloid 1 (TRPV1) is overexpressed in the esophageal mucosa, but its role is not yet fully understood. We evaluated the role of TRPV1 in esophageal inflammation and mucosal barrier impairment in a murine model of NERD. METHODS: Nonerosive reflux disease was surgically induced in Swiss mice by pyloric substenosis and ligature of the gastric fundus, and the mice were killed 7 days post surgery. The experimental groups were: I, sham surgery (negative control); II, NERD untreated; III and IV, NERD + SB366791 or capsazepine (TRPV1 antagonists); and V, NERD + resiniferatoxin (for long-term desensitization of TRPV1). The esophagus was collected for western blotting and histopathology and for evaluation of wet weight, myeloperoxidase (MPO), keratinocyte-derived chemokine (KC), transepithelial electrical resistance (TEER), and basal permeability to fluorescein. KEY RESULTS: Compared to sham, NERD mice had increased esophageal wet weight and MPO and KC levels. The mucosa had no ulcers but exhibited inflammation. NERD mice showed mucosal TRPV1 overexpression, a more pronounced decrease in TEER at pH 0.5 (containing pepsin and taurodeoxycholic acid), and increased basal permeability. Pharmacological modulation of TRPV1 prevented esophageal inflammation development, TEER changes by acidic exposure, and increase in esophageal permeability. CONCLUSIONS & INFERENCES: The TRPV1 receptor has a critical role in esophageal inflammation and mucosal barrier impairment in NERD mice, suggesting that TRPV1 might be a pharmacological target in patients with NERD.
RESUMO
The Raman spectrum of monolayer graphene deposited on the top of a silicon oxide/silicon substrate was investigated as a function of temperature up to 515 K. An anomalous temperature dependence of the Raman features was observed, including an important frequency upshift for the Raman G band at room temperature, after the heating process. On the other hand, the frequency of the Raman G(') band is only slightly affected by the thermal treatment. We discuss our experimental results in terms of doping and strain effects associated with the interaction of graphene with the substrate and with the presence of water in the sample. We conclude that the doping effect gives the most important contribution to the spectral changes observed after the thermal cycle.
Assuntos
Cristalização/métodos , Grafite/química , Nanoestruturas/química , Nanoestruturas/ultraestrutura , Análise Espectral Raman/métodos , Água/química , Difusão , Temperatura Alta , Substâncias Macromoleculares/química , Teste de Materiais , Conformação Molecular , Tamanho da Partícula , Propriedades de SuperfícieRESUMO
The production and physical properties of nanowires and nanoribbons formed by methylphosphonic acid (MPA)--CH3PO(OH)2--were investigated. These structures are formed on an aluminum coated substrate when immersed in an ethanolic solution of MPA for several days. A careful investigation of the growth conditions resulted in a narrow window of solution concentrations and temperatures for the successful development of nanowires and nanoribbons. Several different techniques were employed to characterize these nanostructures: (1) Photoluminescence experiments showed a strong emission at 2.3 eV (green), which is visible to the naked eye; (2) X-ray diffraction experiments indicated a significant cristalinity, in agreement with atomic force microscopy (AFM) and transmission electron microscopy (TEM) morphology images, which show organized nano-scale wires and ribbons, (furthermore, AFM-Phase and TEM images also suggest that nanoribbons are formed by well-aligned nanowires); (3) Conductive-AFM experiments revealed an intermediary conductivity for these structures (10(-1)/Ohm x m), which is similar to some intrinsic semiconductors and; (4) finally, Infrared, Raman, and X-Ray Photoelectron Spectroscopies produced information about the contents, structure, and composition of both wires and ribbons.
Assuntos
Nanopartículas/química , Nanotubos de Carbono/química , Nanofios/química , Compostos Organofosforados/química , Absorção , Alumínio/química , Luz , Microscopia de Força Atômica , Microscopia Eletrônica de Transmissão , Nanotecnologia/métodos , Espectrofotometria Infravermelho/métodos , Análise Espectral Raman/métodos , Temperatura , Difração de Raios XRESUMO
A classical protocol widely used in organic chemistry of aromatic and polyaromatic molecules has been successfully applied in this work for the decarboxylation of oxidized single-wall carbon nanotube (SWNT) to rend C-H SWNT derivatives. SWNT produced by arc discharge method have been oxidized during a purification process using strongly oxidant agents, such as hydrogen peroxide and nitric acid. The decarboxylation of oxidized SWNT has been conduced with copper(I) oxide in a 50:50 solution of N-methylpyrrolidone and quinoline. Fourier transform infrared spectroscopy, X-ray photoelectron spectroscopy and acid-base potentiometric titration analyses were carried out to characterize quali and quantitatively the changes in the chemical environment on the SWNT surface in each step of the purification and the decarboxylation process. Those techniques showed the appearance of mainly carboxylic and phenolic groups after the purification process and the disappearance of the carboxylic groups after the decarboxylation reaction. Fourier transform infrared spectroscopy analysis indicated also the formation of aliphatic and aromatic C-H groups. X-ray photoelectron spectroscopy and potentiometric titration results determined an efficiency higher than 90% for our decarboxylation procedure. The purity and structural quality of the SWNT sample used in the decarboxylation process were evaluated by thermogravimetry and Raman spectroscopy. Thermogravimetric analysis identified a purified sample with approximately 80 wt% of SWNT, in fractions distributed in highly structured SWNTs (25 wt%), with distribution in composition, length and structural quality (35 wt%) and with very defective and short tubes (25 wt%). The damages on the purified SWNT walls were characterized by the Raman scattering analysis.
Assuntos
Cristalização/métodos , Nanotecnologia/métodos , Nanotubos de Carbono/química , Nanotubos de Carbono/ultraestrutura , Oxigênio/química , Substâncias Macromoleculares/química , Teste de Materiais , Conformação Molecular , Oxirredução , Tamanho da Partícula , Propriedades de SuperfícieRESUMO
The photoluminescence (PL) properties of thin films of the conjugated polymer [poly(2,5-bis(2(')-ethyl-hexyl)-1,4-phenylenevinylene] have been investigated. At low temperatures the PL spectra show a narrow peak for the electronic transition and a series of well defined vibronic sidebands, which clearly reveal the electron coupling with two different vibronic modes. The purely electronic transition peak is observed to be very asymmetric so that it cannot be adjusted by a single Lorentzian or Gaussian function. In order to understand and explain this asymmetry we have considered a model where the purely electronic transition line shape is partially generated by a broadened square-root singularity representing one-dimensional electron states, and partially by localized (zero-dimensional) states. The localized states are assumed to be those very close to the band edges and are represented in our model by a single Gaussian function. Numerical Franck-Condon analysis was performed, resulting in a very good agreement between the theoretical and the experimental emission spectra. This procedure has confirmed the one-dimensional character of the electron states as the basis for the understanding of the purely electronic line shape asymmetry in the PL spectra of conjugated polymers at low temperatures.