RESUMO

We characterize the effect of ferromagnetic nickel nanoparticles (size ∼6 nm) on the magnetotransport properties of chemical-vapor-deposited (CVD) graphene. The nanoparticles were formed by thermal annealing of a thin Ni film evaporated on top of a graphene ribbon. The magnetoresistance was measured while sweeping the magnetic field at different temperatures, and compared against measurements performed on pristine graphene. Our results show that, in the presence of Ni nanoparticles, the usually observed zero-field peak of resistivity produced by weak localization is widely suppressed (by a factor of ∼3), most likely due to the reduction of the dephasing time as a consequence of the increase in magnetic scattering. On the other hand, the high-field magnetoresistance is amplified by the contribution of a large effective interaction field. The results are discussed in terms of a local exchange coupling, J∼6 meV, between the graphene π electrons and the 3d magnetic moment of nickel. Interestingly, this magnetic coupling does not affect the intrinsic transport parameters of graphene, such as the mobility and transport scattering rate, which remain the same with and without Ni nanoparticles, indicating that the changes in the magnetotransport properties have a purely magnetic origin.

RESUMO

Theobroma cacao L. species, cultivated worldwide for its valuable beans, generates up to 72% weight of the fruit as waste. The lack of reutilization technologies in the cocoa agroindustry has hindered the exploitation of valuable bio-components applicable to the generation of high value added bioproducts. One such bioproduct is microfibrillated cellulose (MFC), a biopolymer that stands out for its desirable mechanical properties and biocompatibility in biomedical, packing, 3D printing, and construction applications. In this study, we isolated microfibrillated cellulose (MFC) from cocoa pod husk (CPH) via oxalic acid hydrolysis combined with a steam explosion. MFC isolation started with the Solid/Liquid extraction via Soxhlet, followed by mild citric acid hydrolysis, diluted alkaline hydrolysis, and bleaching pre-treatments. A Response Surface Methodology (RSM) was used to optimize the hydrolysis reaction at levels between 110 and 125 °C, 30-90 min at 5-10% (w/v) oxalic acid concentration. The cellulose-rich fraction was characterized by Fourier-Transform Infrared Spectroscopy (FTIR), Thermogravimetric Analysis (TGA), Differential Scanning Calorimetry (DSC), X-Ray Diffraction (XRD), and Scanning Electron Microscopy (SEM) analyses. Characterization analyses revealed a cellulose-rich polymer with fibers ranging from 6 to 10 µm, a maximum thermal degradation temperature of 350 °C, and a crystallinity index of 63.4% (peak height method) and 29.0% (amorphous subtraction method). The optimized hydrolysis conditions were 125 °C, 30 min, at 5% w/v oxalic acid: with a 75.7% yield. These results compare with MFC obtained through highly concentrated inorganic acid hydrolysis from different biomass sources. Thus, we show a reliable and greener alternative chemical treatment for the obtention of MFC.

RESUMO

Magnetic nanoparticles based on iron oxides (MNPs-Fe) have been proposed as photothermal agents (PTAs) within antibacterial photothermal therapy (PTT), aiming to counteract the vast health problem of multidrug-resistant bacterial infections. We present a quick and easy green synthesis (GS) to prepare MNPs-Fe harnessing waste. Orange peel extract (organic compounds) was used as a reducing, capping, and stabilizing agent in the GS, which employed microwave (MW) irradiation to reduce the synthesis time. The produced weight, physical-chemical features and magnetic features of the MNPs-Fe were studied. Moreover, their cytotoxicity was assessed in animal cell line ATCC RAW 264.7, as well as their antibacterial activity against Staphylococcus aureus and Escherichia coli. We found that the 50GS-MNPs-Fe sample (prepared by GS, with 50% v/v of NH4OH and 50% v/v of orange peel extract) had an excellent mass yield. Its particle size was ~50 nm with the presence of an organic coating (terpenes or aldehydes). We believe that this coating improved the cell viability in extended periods (8 days) of cell culture with concentrations lower than 250 µg·mL-1, with respect to the MNPs-Fe obtained by CO and single MW, but it did not influence the antibacterial effect. The bacteria inhibition was attributed to the plasmonic of 50GS-MNPs-Fe (photothermal effect) by irradiation with red light (630 nm, 65.5 mW·cm-2, 30 min). We highlight the superparamagnetism of the 50GS-MNPs-Fe over 60 K in a broader temperature range than the MNPs-Fe obtained by CO (160.09 K) and MW (211.1 K). Therefore, 50GS-MNPs-Fe could be excellent candidates as broad-spectrum PTAs in antibacterial PTT. Furthermore, they might be employed in magnetic hyperthermia, magnetic resonance imaging, oncological treatments, and so on.

Assuntos

RESUMO

Hydrogels are promising candidates for wound healing bandages because they can mimic the native skin microenvironment. Additionally, there is increasing growth in the use of naturally derived materials and plant-based biomaterials to produce healthcare products with healing purposes because of their biocompatibility and biodegradation properties. In this study, cellulose extracted from biodiverse sources in Ecuador was used as the raw material for the fabrication of hydrogels with enhanced antifouling properties. Fourier-transform infrared (FTIR) spectroscopy, X-ray diffraction (XRD), and scanning electron microscopy (SEM) were used to characterize the cellulose and hydrogels. In vitro and ex vivo tests were performed to evaluate the antimicrobial activity of hydrogels against Gram-negative bacteria as a model. Finally, the hydrogel synthesized with cellulose extracted from pitahaya showed improved antibacterial activity when applied over pigskin as a proof of concept for wound dressing. Therefore, the present results suggest that cellulose-based hydrogels are good candidates for application as wound dressings.

Assuntos

RESUMO

Microbial diseases have been declared one of the main threats to humanity, which is why, in recent years, great interest has been generated in the development of nanocomposites with antimicrobial capacity. The present work studied two magnetic nanocomposites based on graphene oxide (GO) and multiwall carbon nanotubes (MWCNTs). The synthesis of these magnetic nanocomposites consisted of three phases: first, the synthesis of iron magnetic nanoparticles (MNPs), second, the adsorption of the photosensitizer menthol-Zinc phthalocyanine (ZnMintPc) into MWCNTs and GO, and the third phase, encapsulation in poly (N-vinylcaprolactam-co-poly(ethylene glycol diacrylate)) poly (VCL-co-PEGDA) polymer VCL/PEGDA a biocompatible hydrogel, to obtain the magnetic nanocomposites VCL/PEGDA-MNPs-MWCNTs-ZnMintPc and VCL/PEGDA-MNPs-GO-ZnMintPc. In vitro studies were carried out using Escherichia coli and Staphylococcus aureus bacteria and the Candida albicans yeast based on the Photodynamic/Photothermal (PTT/PDT) effect. This research describes the nanocomposites' optical, morphological, magnetic, and photophysical characteristics and their application as antimicrobial agents. The antimicrobial effect of magnetics nanocomposites was evaluated based on the PDT/PTT effect. For this purpose, doses of 65 mW·cm-2 with 630 nm light were used. The VCL/PEGDA-MNPs-GO-ZnMintPc nanocomposite eliminated E. coli and S. aureus colonies, while the VCL/PEGDA-MNPs-MWCNTs-ZnMintPc nanocomposite was able to kill the three types of microorganisms. Consequently, the latter is considered a broad-spectrum antimicrobial agent in PDT and PTT.