RESUMO

An iron(III) complex with ionic tags was applied to the reduction of alkenes in imidazolium-based ionic liquids (ILs) under oxidative conditions. The catalyst is very efficient to promote reactions of biomass derivatives. At least ten recycling reactions were performed without any loss of catalytic activity. Some important mechanistic insights for this new reaction are also provided based mostly on electrospray ionization quadrupole-time of flight mass spectrometry (ESI-QTOF-MS).

Assuntos

RESUMO

A new ionophilic ligand and a new ionically tagged imidazolium-based iron(III) complex were synthesized and applied in the air oxidation (also hydrogen peroxide) of alkenes in imidazolium-based ionic liquids. At least ten recycling reactions were performed. The epoxidized olefin was obtained in very good yields of 84-91 %. Some important mechanistic insights are also provided based on electrospray ionization quadrupole-time of flight mass spectrometry for the oxidation reaction. These results indicate that oxidations can take place by two different pathways, depending on the reaction condition: a radical or a concerted mechanism. These results contribute towards a better understanding of iron-catalyzed oxidation mechanisms.

Assuntos

RESUMO

Biodiesel and diesel-like have been obtained from soybean oil by transesterification and thermal cracking process, respectively. These biofuels were characterized as according to ANP standards by using specific ASTM methods. Ethanol, gasoline, and diesel were purchased from a gas station. Deacetylation degree of chitosan was determined by three distinct methods (conductimetry, FTIR and NMR), and the average degree was 78.95%. The chitosan microspheres were prepared from chitosan by split-coating and these spheres were crosslinked using glutaraldehyde. The surface area of microspheres was determined by BET method, and the surface area of crosslinked microspheres was 9.2m(2)g(-1). The adsorption isotherms of cooper, nickel and zinc on microspheres of chitosan were determined in petroleum derivatives (gasoline and diesel oil), as well as in biofuels (alcohol, biodiesel and diesel-like). The adsorption order in all fuels was: Cu>Ni>Zn. The elution tests presented the following preconcentration degrees: >4.5 to ethanol, >4.4 to gasoline, >4.0 to diesel, >3.8 to biodiesel and >3.6 to diesel-like. The application of chitosan microspheres in the metal ions preconcentration showed the potential of this biopolymer to enrich fuel sample in order to be analyzed by flame atomic absorption spectrometry.

Assuntos

RESUMO

Pyrolysis of industrial fatty wastes (soybean soapstock, beef tallow, and poultry industry waste) was carried out in the absence of catalysts. In all cases, organic mixtures of hydrocarbons and oxygenated compounds were obtained. These mixtures were distilled and diesel-like fractions were isolated and characterized by GC-FID, GC-MS and FT-IR, showing the formation of olefins, paraffins, and some oxygenated compounds such as carboxylic acids and esters. The main physical-chemical properties of those isolated diesel-like fuels (density, viscosity, distillation curve, carbon residue, copper corrosion test, cetane index, cold finger plugging point, acid index and heating value) were determined using ASTM standard methods and matched the Brazilian specification for diesel fuel.

Assuntos

RESUMO

Three different calibration curves based on (1)H-NMR spectroscopy (300 MHz) were used for quantifying the reaction yield during biodiesel synthesis by esterification of fatty acids mixtures and methanol. For this purpose, the integrated intensities of the hydrogens of the ester methoxy group (3.67 ppm) were correlated with the areas related to the various protons of the alkyl chain (olefinic hydrogens: 5.30-5.46 ppm; aliphatic: 2.67-2.78 ppm, 2.30 ppm, 1.96-2.12 ppm, 1.56-1.68 ppm, 1.22-1.42 ppm, 0.98 ppm, and 0.84-0.92 ppm). The first curve was obtained using the peaks relating the olefinic hydrogens, a second with the parafinic protons and the third curve using the integrated intensities of all the hydrogens. A total of 35 samples were examined: 25 samples to build the three different calibration curves and ten samples to serve as external validation samples. The results showed no statistical differences among the three methods, and all presented prediction errors less than 2.45% with a co-efficient of variation (CV) of 4.66%.

Assuntos

RESUMO

This is the first report of in situ SER spectra of chemical species adsorbed on a Ag/room temperature ionic liquid (RTIL) interface. We have investigated the dependence of the SERS intensity of the RTIL derived from 1-n-butyl-3-methylimidazolium hexafluorophosfate (BMIPF6) adsorbed on a silver electrode. It has been shown that the BMI+ adsorbs on the silver electrode for potentials more negative than -0.4 V vs a Pt quasireference electrode (PQRE). In the -0.4 to -1.0 V potential range the SER spectra are similar to the Raman spectrum of the RTIL BMIPF6. At potentials more negative than -1.0 V some imidazolium ring vibrational modes and N-CH3 vibrations are enhanced, suggesting that the imidazolium ring is parallel to the surface and for potentials <-2.8 V the BMI+ is reduced to the BMI carbene. The potential dependence of the SERS intensities of Py adsorbed on a silver electrode in BMIPF6 has also been investigated. The results have shown that at potentials less negative than -0.8 V (vs PQRE) Py adsorbs at an end-on configuration forming an Ag-N bond. In the -0.9 to -1.4 V potential range Py molecules lie flat on the electrode surface and at potentials <-1.4 V Py is replaced by the BMI+. The electrochemical and SERS results have shown that Py has the effect of changing the oxidation of silver in that medium as well as the reduction of BMI+ to the BMI carbene. In the presence of Py the BMI+ reduction is observed at potentials near -2.4 V. The Ag electrode has presented SERS activity from 0.0 to -3.0 V.

RESUMO

Among the various properties exhibited by ionic liquids (ILs)--especially those based on the imidazolium cation-their inherent ionic patterns, very low vapour pressure and pronounced self-organization in the solid, liquid and even in the gas phase are particularly interesting since this allows the use of these fluids as alternative and complementary media to classical organic solvents and water in many applications. Hence, reaction paths that involve charge-separated intermediates or transition states are accelerated--by lowering the activation barrier-in the presence of ILs when compared with those performed in classical organic solvents. It is also possible, for example, to observe, by electrochemical methods, transient species (ionic and radical) that are otherwise undetectible in water or in molecular organic solvents and to investigate the interactions and behaviour of molecular, biological and macromolecular species in solution using physical and chemical methods which require special conditions such as high-vacuum, and which have been traditionally limited to solid state chemistry.

RESUMO

Partial last square regression (PLS) and artificial neural network (ANN) combined to FTIR-ATR and FTNIR spectroscopies have been used to design calibration models for the determination of methyl ester content (%, w/w) in biodiesel blends (methyl ester+diesel). Methyl esters were obtained by the methanolysis of soybean, babassu, dende, and soybean fried oils. Two sets of samples have been used: Group I, binary mixtures (diesel+one kind of methyl ester), corresponding to 96 biodiesel blends (0-100%, w/w), and Group II, quaternary mixtures (diesel+three types of methyl esters), corresponding to 60 biodiesel blends (0-100%, w/w). The PLS results have shown that the FTNIR model for Group I is more precise and accurate (+/-0.02 and +/-0.06%, w/w). In the case of Group II the PLS models (FTIR-ATR and FTNIR) have shown the same accuracies, while the ANN/FTNIR models has presented better performance than the ANN/FTIR-ATR models. The best accuracy was achieved by the ANN/FTNIR model for diesel determination (0.14%, w/w) while the worthiest was that of dende ANN/FTIR-ATR model (0.6%, w/w). Precisions in Group II analysis ranged from 0.06 to 0.53% (w/w) and coefficients of variation were better than 3% indicating that these models are suitable for the determination of diesel-biodiesel blends composed of methyl esters derived from different vegetable oils.

RESUMO

A comparative study of rubber sheets obtained using formic, acetic, and smoke acid as coagulants is shown for latex obtained from native Amazonian trees and also from commercial cultivated trees. The evaluation of both processes of coagulation was carried out by spectroscopic and physical-chemical analysis, showing no differences in the rubber sheets obtained. This new method of rubber sheet preparation was introduced into Amazonian rainforest rubber tapper communities, which are actually producing in large scale. The physical-mechanical properties were similar among a large sheets made by different rubber tapper communities using this new method.

Assuntos

RESUMO

The nature of the interactions between 1,3-dialkylimidazolium cations and noncoordinating anions such as tetrafluoroborate, hexafluorophosphate, and tetraphenylborate has been studied in the solid state by X-ray diffraction analysis and in solution by (1)H NMR spectroscopy, conductivity, and microcalorimetry. In the solid state, these compounds show an extended network of hydrogen-bonded cations and anions in which one cation is surrounded by at least three anions and one anion is surrounded by at least three imidazolium cations. In the pure form, imidazolium salts are better described as polymeric supramolecules of the type {[(DAI)(3)(X)](2+)[(DAI)(X)(3)](2-)}(n) (where DAI is the dialkylimidazolium cation and X is the anion) formed through hydrogen bonds of the imidazolium cation with the anion. In solution, this supramolecular structural organization is maintained to a great extent, at least in solvents of low dielectric constant, indicating that mixtures of imidazolium ionic liquids with other molecules can be considered as nanostructured materials. This model is very useful for the rationalization of the majority of the unusual behavior of the ionic liquids.