RESUMO

Mg2SiO4:Tb phosphor exhibits four thermoluminescence (TL) peaks at 124, 244, 300 and 370°C for a heating rate of 2°C/s, 244°C peak being the main dosimetry peak. The irradiated phosphor exhibits CW-OSL response on stimulation with blue (470nm) light. Thermal decay of OSL shows that all the TL traps contribute to CW-OSL signal. Its TL and OSL sensitivities are 0.21 and 0.038, respectively, than that of Al2O3:C (Landauer Inc.). Its CW-OSL response increases linearly up to 30Gy, thereafter increase was supralinear up to the studied dose of 1000Gy. Electron Spin Resonance (ESR) studies were carried out to study the defect centers induced in the phosphor by gamma irradiation and also to identify the centers responsible for the TL process. Room temperature ESR spectrum of irradiated phosphor appears to be a superposition of at least three distinct centers. One of the centers (center I) with an isotropic g-factor 2.0122 is attributable to an intrinsic O(-) radical and this correlates with the main TL peak at 244°C. Center II with an isotropic g-factor 2.0012 is assigned to an F(+)-center (singly ionized oxygen vacancy) and is the likely recombination center for all the TL peaks. Both the centers grow with radiation dose at least up to 1 kGy. Center III with an axial symmetric g-tensor with principal g-values g||=2.0049 and g⊥=2.0029 is identified as an F(+)-center and is not related to the observed TL peaks in the phosphor.

RESUMO

The present work deals with the parameter identification problem in outflow models used in one-dimensional simulations of arterial blood flow. Specifically, the resistive elements that define the models used to account for the blood supply to the vascular territories in arterial networks are computed by solving a system of non-linear equations using a Broyden method. This strategy is employed to compute the terminal parameters in the vascular territories of an anatomically detailed model of the arm comprising 67 arterial segments and 16 vascular territories. A comparison with a simple analytical approach, in terms of vascular territory resistances, average blood flows and time-dependent hemodynamic quantities, is performed. Also, a sensitivity analysis is presented to assess the performance of this new approach in normal and abnormal cardiovascular scenarios. This identification procedure allows to correctly set up hemodynamics simulations in highly detailed arterial networks making possible to gain insight in the aspects related to the blood circulation in arterial vessels.

Assuntos

Assuntos

RESUMO

INTRODUCTION: antagonists of angiotensin II receptor (AAR) are commonly used for the treatment of chronic hypertension in the general population. Some of these pharmacological agents are losartan, candesartan, valsartan and tasosartan. Despite the good response achieved with these drugs in the control of hypertension, all medications that act directly on the renin-angiotensin system should be contraindicated during pregnancy. These drugs have been associated with fetal and neonatal injury, including hypotension, neonatal skull hypoplasia, anuria, reversible or irreversible renal failure and death.Here we report a case of fetal malformations and death associated with the use of losartan. OBJECTIVES: describing the association of fetal malformations and the use of losartan during first and second trimester of pregnancy. METHODS: this is a case report involving a 37-year-old pregnant woman at 26 gestational weeks. This patient had history of chronic hypertension for more than five years that was being regularly treated with Losartan 50mg/day. After her first consultation losartan was promptly discontinued and substituted for methyldopa. However, scan evaluation demonstrated severe oligohydramnios associated with altered fetal biophysical profile and altered Doppler fluxometry (absent diastolic flow at umbilical arteries). Therefore, a cesarean-section was performed after corticoid administration for fetal lung maturation. At first moment some characteristic alterations as fetal limb contractures and craniofacial deformation were detected at the 1007g new-born. This baby went to death 36h after delivery due to severe lung hypoplasia. RESULTS: the autopsy examination revealed renal tubular dysgenesis associated with changes secondary to nephropathy, probably induced by drug (Fig. 1). Associated findings were underdevelopment of bones of the skull with large fontanelles, thymus atrophy and signs of perinatal hypoxia. CONCLUSION: the difficulty of attending basic health assistance was attributed to be associated with this case, as this patient did not have opportunity and sufficient information about the necessity of changing her medication during pregnancy. Apart from this situation, this case report brings good information about the association between antagonists of angiotensin II receptor and human fetal malformations.

RESUMO

Natural silicate mineral of zoisite, Ca(2)Al(3)(SiO(4))(Si(2)O(7))O(OH), has been investigated concerning γ-radiation, UV-radiation and high temperature annealing effects on thermoluminescence (TL). X-ray diffraction (XRD) measurement confirmed zoisite structure and X-ray fluorescence (XRF) analysis revealed besides Si, Al and Ca that are the main crystal components, other oxides of Fe, Mg, Cr, Na, K, Sr, Ti, Ba and Mn which are present in more than 0.05 wt%. The TL glow curve of natural sample contains (130-150), (340-370) and (435-475)°C peaks. Their shapes indicated a possibility that they are result of composition of two or more peaks strongly superposed, a fact confirmed by deconvolution method. Once pre-annealed at 600°C for 1h, the shape of the glow curves change and the zoisite acquires high sensitivity. Several peaks between 100 and 400°C appear superposed, and the high temperature peak around 435°C cannot be seen. The ultraviolet radiation, on the other hand, produces one TL peak around 130°C and the second one around 200°C and no more.

Assuntos

RESUMO

Two indigenous ceramics fragments, one from Lagoa Queimada (LQ) and another from Barra dos Negros (BN), both sites located on Bahia state (Brazil), were dated by thermoluminescence (TL) method. Each fragment was physically prepared and divided into two fractions, one was used for TL measurement and the other for annual dose determination. The TL fraction was chemically treated, divided in sub samples and irradiated with several doses. The plot extrapolation from TL intensities as function of radiation dose enabled the determination of the accumulated dose (D(ac)), 3.99 Gy and 1.88 Gy for LQ and BN, respectively. The annual dose was obtained through the uranium, thorium and potassium determination by ICP-MS. The annual doses (D(an)) obtained were 2.86 and 2.26 mGy/year. The estimated ages were approximately 1375 and 709 y for BN and LQ ceramics, respectively. The ages agreed with the archaeologists' estimation for the Aratu and Tupi tradition periods, respectively.

Assuntos

RESUMO

Ancient potteries usually are made of the local clay material, which contains relatively high concentration of iron. The powdered samples are usually quite black, due to magnetite, and, although they can be used for thermoluminescene (TL) dating, it is easiest to obtain better TL reading when clearest natural or pre-treated sample is used. For electron paramagnetic resonance (EPR) measurements, the huge signal due to iron spin-spin interaction, promotes an intense interference overlapping any other signal in this range. Sample dating is obtained by dividing the radiation dose, determined by the concentration of paramagnetic species generated by irradiation, by the natural dose so as a consequence, EPR dating cannot be used, since iron signal do not depend on radiation dose. In some cases, the density separation method using hydrated solution of sodium polytungstate [Na6(H2W12O40).H2O] becomes useful. However, the sodium polytungstate is very expensive in Brazil; hence an alternative method for eliminating this interference is proposed. A chemical process to eliminate about 90% of magnetite was developed. A sample of powdered ancient pottery was treated in a mixture (3:1:1) of HCl, HNO(3) and H(2)O(2) for 4h. After that, it was washed several times in distilled water to remove all acid matrixes. The original black sample becomes somewhat clearer. The resulting material was analyzed by plasma mass spectrometry (ICP-MS), with the result that the iron content is reduced by a factor of about 9. In EPR measurements a non-treated natural ceramic sample shows a broad spin-spin interaction signal, the chemically treated sample presents a narrow signal in g=2.00 region, possibly due to a radical of (SiO(3))(3-), mixed with signal of remaining iron [M. Ikeya, New Applications of Electron Spin Resonance, World Scientific, Singapore, 1993, p. 285]. This signal increases in intensity under gamma-irradiation. However, still due to iron influence, the additive method yielded too old age-value. Since annealing at 300 degrees C, Toyoda and Ikeya [S. Toyoda, M. Ikeya, Geochem. J. 25 (1991) 427-445] states that E1'-signal with maximum intensity is obtained, while annealing at 400 degrees C E1'-signal is completely eliminated, the subtraction of the second one from 300 degrees C heat-treated sample isolate E1'-like signal. Since this is radiation dose-dependent, we show that now EPR dating becomes possible.

Assuntos

RESUMO

In the present work, dating of one type of amazonite sample using the [Pb-Pb]3+ dimeric center is carried out by electron spin resonance (ESR). The thermal stability of the center is investigated using isochronal annealing at several temperatures from 200 to 500 degrees C for 15 min. Using isothermal annealing, the lifetime of the center was also estimated. The extrapolation of the straight line in the Arrhenius plot gives a lifetime of approximately 0.25 Ma at room temperature. The age obtained from sample was 90 ka.

RESUMO

Strong doubts havc been expressed about the validity of the quasi-equilibrium (QE) assumption used in the derivation of the analytical expressions of thermoluminescence (TL). So far there is no established method available to check if QE actually prevails during the emission of an experimental TL signal. The present study shows that the level of QE changes with a change in the heating rate beta. The change in the level of QE in its turn gets reflected in a change in peak shape when the system turns to a non-QE condition. This property is used as the first ever experimental method to test whether or not the emission of a given glow peak occurs under the QE condition. An essential condition for holding the QE condition is found to be T(R)/taum> or = 10(-3) where T(R) and taum are the glow peak recording duration and the maximum value of the free carrier lifetime, respectively. This relation between T(R) and taum is useful in finding the approximate value of taum. The value of taum being a function of the concentration and cross section of the TL related centres, one may be able to assess these basic parameters from the study of TL glow curves. The theoretical results are discussed in the perspective of LiF (TLD-100).

Assuntos

RESUMO

The TL, optical absorption (OA) and EPR properties of natural Brazilian alexandrite and chrysoberyl have been investigated. The TL measurements for natural alexandrite show five peaks between 100 and 450 degrees C, with their emission spectrum having 370 and/or 570 nm components. The intensity of the 320 degrees C TL peak was found to be enhanced with pre-annealing treatment, more prominently above 600 degrees C. The OA and EPR measurements showed that this kind of heat treatment induces the Fe2+ --> Fe3+ conversion in the natural sample. Chrysoberyl samples exhibited the TL peaks at the same temperatures as alexandrite samples, but the glow curves were more than 200 times less intense than alexandrite ones.

Assuntos