RESUMO
Bile acids (BAs) are derived from cholesterol and produced in the liver. The most abundant bile acids in humans are usually conjugated with glycine and taurine and are divided into primary BAs such as cholic acid (CA) and chenodeoxycholic acid (CDCA) and secondary BAs like deoxycholic acid (DCA), lithocholic acid (LCA) and ursodeoxycholic acid (UDCA). The differences amongst individual bile acids (BAs) are significant in order to distinguish different pathological processes and exposure to chemical compounds. Hollow fiber based liquid-phase microextraction (HF-LPME) is a technique that combines sample cleansing, extraction and the concentration of analytes, where a hydrophobic porous capillary membrane is impregnated with an organic extraction solvent and the lumen is filled with microliters of a phase acceptor both organic by nature. The aim of this study was to develop a new method to extract bile acids from plasma through HF-LPME of two phases (octanol as the acceptor phase) using LCMS-IT-TOF. The optimized two-phased LPME procedure for the extraction of bile acids showed limits of detection 1.0 µg L(-1) and limits of quantification of 5.0 µg L(-1). The intra-assay precision ranged from 2.1 to 11.9%. The method developed was linear over the range of 5.0-200.0 µg L(-1) for all analytes. The hollow-fiber liquid-phase microextraction method was applied to human plasma from workers exposed to organic and halogenated solvents and also to unexposed volunteers. The method is simple, low cost and it does not require large amounts of organic solvents, therefore it is quite suitable for the analysis of bile acids exposed to hepatotoxic compounds.
Assuntos
Ácidos e Sais Biliares/sangue , Cromatografia Líquida/métodos , Microextração em Fase Líquida/métodos , Exposição Ocupacional/análise , Espectrometria de Massas por Ionização e Dessorção a Laser Assistida por Matriz/métodos , Adulto , Estudos de Casos e Controles , Humanos , Pessoa de Meia-IdadeRESUMO
RATIONALE: Environmental bisphenol A (BPA) contamination is currently a matter of concern. This compound can disrupt the endocrine system by mimicking natural hormones and cause adverse effects on different organisms. In addition, it has been suggested that BPA can impair brain development, especially in fetuses and children. To efficiently remove BPA from contaminated water and wastewaters, several emerging technologies have been developed. Most are based on photodegradation. However, by-products resulting from the application of such methods have not been properly characterized. METHODS: The photodegradation of BPA was conducted using two different methods: photocatalysis (TiO2/UV-A and TiO2/UV-C systems) and direct photolysis (UV-A and UV-C radiation). The degradation process was continuously monitored to identify and observe the by-products formed under these conditions. Direct infusion electrospray ionization coupled to high-resolution mass spectrometry in negative ion mode [ESI(-)-HRMS] and liquid chromatography coupled to high-resolution mass spectrometry (HPLC/HRMS) were employed to monitor these by-products. RESULTS: The results revealed that the TiO2/UV-C system was the most efficient in causing both BPA depletion and mineralization of the organic matter in solution. Moreover, accurate mass data allowed for the assignment of molecular formulae for seven by-products, many of them unprecedented, formed under these conditions. Thus, a route for the photodegradation of BPA in aqueous medium could be proposed based on these results. Finally, additional tests revealed that the by-products showed a higher toxicity against Artemia salina than the primary precursor. CONCLUSIONS: All of these findings indicate that the identification of by-products arising from oxidative treatments is of primary importance because such compounds can be more hazardous than their precursors.
RESUMO
The degradation of the pharmaceutical compound ibuprofen (IBP) in aqueous solution induced by direct photolysis (UV-A and UV-C radiation) and photocatalysis (TiO2 /UV-A and TiO2 /UV-C systems) was evaluated. Initially, we observed that whereas photocatalysis (both systems) and direct photolysis with UV-C radiation were able to cause an almost complete removal of IBP, the mineralization rates achieved for all the photodegradation processes were much smaller (the highest value being obtained for the TiO2 /UV-C system: 37.7%), even after an exposure time as long as 120 min. Chemical structures for the by-products formed under these oxidative conditions (11 of them were detected) were proposed based on the data from liquid chromatography coupled to high-resolution mass spectrometry (LC-HRMS) analyses. Taking into account these results, an unprecedented route for the photodegradation of IBP could thus be proposed. Moreover, a fortunate result was achieved herein: tests against Artemia salina showed that the degradation products had no higher ecotoxicities than IBP, which possibly indicates that the photocatalytic (TiO2 /UV-A and TiO2 /UV-C systems) and photolytic (UV-C radiation) processes can be conveniently employed to deplete IBP in aqueous media.