RESUMO
Reclaimed water poses environmental and human health risks due to residual organic micropollutants and pathogens. Ozonation of reclaimed water to control pathogens and trace organics is an important step in advanced water treatment systems for potable reuse of reclaimed water. Ensuring efficient pathogen reduction while controlling disinfection byproducts remains a significant challenge to implementing ozonation in reclaimed water reuse applications. This study aimed to investigate ozonation conditions using a plug flow reactor (PFR) to achieve effective pathogen removal/inactivation while minimizing bromate and N-Nitrosodimethylamine (NDMA) formation. The pilot scale study was conducted using three doses of ozone (0.7, 1.0 and 1.4 ozone/total organic carbon (O3/TOC) ratio) to determine the disinfection performance using actual reclaimed water. The disinfection efficiency was assessed by measuring total coliforms, Escherichia coli (E. coli), Pepper Mild Mottle Virus (PMMoV), Tomato Brown Rugose Fruit Virus (ToBRFV) and Norovirus (HNoV). The ozone CT values ranged from 1.60 to 13.62 mg min L-1, resulting in significant reductions in pathogens and indicators. Specifically, ozone treatment led to concentration reductions of 2.46-2.89, 2.03-2.18, 0.46-1.63, 2.23-2.64 and > 4 log for total coliforms, E. coli, PMMoV, ToBRFV, and HNoV, respectively. After ozonation, concentrations of bromate and NDMA increased, reaching levels between 2.8 and 12.0 µg L-1, and 28-40.0 ng L-1, respectively, for average feed water bromide levels of 86.7 ± 1.8 µg L-1 and TOC levels of 7.2 ± 0.1 mg L-1. The increases in DBP formation were pronounced with higher ozone dosages, possibly requiring removal/control in subsequent treatment steps in some potable reuse applications.
RESUMO
Emerging pollutants have received increasing attention because of their potential environmental risks. As conventional treatment processes are not able to completely remove emerging pollutants, such as drugs, for example, the adsorption process is considered a complementary treatment. However, after some time of use, the adsorbent solids used in this type of process become saturated and there may be a higher demand for replacement of these materials, resulting in a large amount of solid waste. In this context, the objective of this study was to evaluate regeneration techniques of adsorbent solid depleted with emerging tetracycline pollutant. For this, tests were performed using three regenerative methods - thermal, chemical and ultrasonic, where through them were analyzed the influence of temperature, type of solvent and sonification time, respectively. Virgin, saturated and regenerated solids were characterized by their physical structure, micro and mesopore distribution and scanning electron microscopy. For all techniques employed, the regeneration efficiency reached values â£â£above 85%. Thermal treatments at 200°C, 100% methanol solution, 100% deionized water with 60 °C heating and ultrasonic treatment at 5 and 20 minutes were chosen as the most viable methods for the study of adsorption/desorption cycles. Compared to the others, the heat treatment at 200°C remained with consistent results until the sixth cycle, presenting a regenerative capacity of 90%. Therefore, it has been selected as the most suitable regenerative agent, ensuring that CAG can be regenerated and used repeatedly in the treatment of tetracycline contaminated waters.