RESUMO
The work investigates the potential of peanut shells, an abundant agro-industrial waste, to serve as an adsorbent precursor for the effective and simple treatment of effluents loaded with cadmium and nickel ions. Among the adsorbents prepared, carbonized peanut shell (CCarb), due to its higher adsorption capacity, proved to be the most effective compared to carbonized and activated peanut shell (CATQ). The carbonization process led to structural changes, which resulted in an increase in surface area (around 6 times more in CATQ) and pore volume (around 3 times more in CATQ). Even so, the amount of H+ acid sites due to acid activation produced unfavorable effects for adsorption. Hydroxyl, carboxyl and carbonyl groups were identified on the adsorbent surface which presented favorable charges for metal adsorption. This improvement propels the carbonized variant to the forefront, demonstrating the highest adsorption capacity and reaching equilibrium in less than 90 and 60 min for cadmium and nickel ions, respectively. In both monocomponent and bicomponent systems concentrations greater than 40 ppm signify an increase in adsorption capacity for Ni2+. The experimental data best fit the Freundlich model, showing maximum adsorption capacities of 17.04 mg g-1 for cadmium and 31.28 mg g-1 for nickel. Despite the antagonistic effect observed in the bicomponent system, this study concludes by underlining the promise of activated carbon from peanut shells to harmonize technical and environmental concerns.
Assuntos
Níquel , Poluentes Químicos da Água , Cádmio , Arachis , Adsorção , Bismuto , Íons , Cinética , Poluentes Químicos da Água/análise , Concentração de Íons de HidrogênioRESUMO
This article presents a study on the degradation of a residual textile mixture composed of cationic surfactant cetyltrimethylammonium bromide (CTAB) and the remazol yellow gold RNL-150% and reactive blue BF-5G textile dyes. This was carried out by employing the photo-peroxidation and photo-Fenton processes in LED and UV-C photoreactors. The photo-Fenton process was the most efficient as regards the degradation of the CTAB and dye mixture, for both types of radiation. In the kinetic study, degradations of 99% were obtained in 180 min for the chromophore groups using both types of radiation. The degradation of the CTAB and aromatic groups was, meanwhile, an average of 25% when employing LED radiation. The behavior of the degradation reaction was pseudo-first-order. Toxicity tests indicated that the solutions were better able to grow seeds and bacteria after treatment with the photo-Fenton process, using both types of radiation. The photo-Fenton processes carried out by employing LED and UV-C photoreactors were able to degrade the CTAB and dye mixture, thus highlighting the efficiency of LED radiation when its power (three times smaller) is compared to that of UV-C radiation. This process, therefore, represents an alternative for use in textile wastewater treatment systems.