RESUMO
ABSTRACT The Brazilian Savanna biome has the largest plant diversity among savannas worldwide and is the predominant biome in Goiás state, Brazil. Among plant species previously catalogued in the Brazilian Savanna, the Myrtaceae family has received attention, as these plants show great economic potential for its medicinal properties, food and ecological importance, highlighting in this context the Psidium genus. In order to contribute to the differentiation of problematic taxonomic groups, such as Myrtaceae, and to quality control of its plant material, morphological and venation leaf studies of four species of Psidium were performed. For this purpose, leaf samples of Psidium firmum O.Berg., P. myrsinites DC., P. laruotteanum Cambes., and P. guineense Sw. were collected from Goiás State University, Anápolis Air Base, and Serra de Caldas Novas State Park and submitted to classical techniques for morphological and leaf venation characterizations. The results showed that P. firmum presents brochidodromous secondary veins, marginal last venation of the fimbrial type, an abaxial surface with a grooved midrib, flat secondary veins on both sides, an apex obtuse to mucronate, and a rounded base. P. guineense presents trichomes on both surfaces, a grooved midrib on the adaxial surface and a prominent midrib on the abaxial surface, which distinguishes this species from all other Myrtaceae species examined in the present study. The species P. guineense and P. firmum presented a set of differential leaf characteristics among the others taxa of the genus, clearly separating these plants in the morphological identification key.
RESUMO
ABSTRACT The leaves extracts of some species of Bauhinia L. s.l. are consumed to treat diabetes, inflammation, pains and several disorders in traditional medicine in austral South America. Despite its wide use and commercialization, sale is not controlled, and botanical quality of samples is not always adequate because of plant misidentification and adulteration. Here, we characterized leaf vein pattern in nineteen taxa to contribute to the recognition and commercial quality control of plant material commercially available. The vein characters intercostal tertiary and quinternary vein fabric, areole development and shape, free ending veinlet branching and marginal ultimate venation allowed to distinguish the main medicinal species in the region.
RESUMO
BACKGROUND AND AIMS: The influence of leaf mechanical properties on local ecosystem processes, such as trophic transfer, decomposition and nutrient cycling, has resulted in a growing interest in including leaf mechanical resistance in large-scale databases of plant functional traits. 'Specific work to shear' and 'force to tear' are two properties commonly used to describe mechanical resistance (toughness or strength) of leaves. Two methodologies have been widely used to measure them across large datasets. This study aimed to assess correlations and standardization between the two methods, as measured by two widely used apparatuses, in order to inter-convert existing data in those global datasets. METHODS: Specific work to shear (W(SS)) and force to tear (FT) were measured in leaves of 72 species from south-eastern Australia. The measurements were made including and excluding midribs. Relationships between the variables were tested by Spearman correlations and ordinary least square regressions. KEY RESULTS: A positive and significant correlation was found between the methods, but coefficients varied according to the inclusion or exclusion of the midrib in the measurements. Equations for prediction varied according to leaf venation pattern. A positive and significant (r = 0·90, P < 0·0001) correlation was also found between W(SS) values for fresh and rehydrated leaves, which is considered to be of practical relevance. CONCLUSIONS: In the context of broad-scale ecological hypotheses and used within the constraints recommended here, leaf mechanical resistance data obtained with both methodologies could be pooled together into a single coarser variable, using the equations provided in this paper. However, more detailed datasets of FT cannot be safely filled in with estimations based on W(SS), or vice versa. In addition, W(SS) values of green leaves can be predicted with good accuracy from W(SS) of rehydrated leaves of the same species.
Assuntos
Bases de Dados como Assunto , Folhas de Planta/fisiologia , Característica Quantitativa Herdável , Fenômenos Biomecânicos , Modelos Lineares , Estatísticas não ParamétricasRESUMO
The present research aimed to evaluate the foliar morphology (morphometry and leaf venation) of origins of maté collected in southern Brazil and Argentina. For the study of the morphometry, thirty leaves/plant were analyzed, and five measurements (leaf total length, maximum width, length from the base until maximum width, area and petiole length) and two indices were obtained (total leaf length on maximum width and length from basis until maximum width on total leaf length). The leaves were clarified by the clarification technique and examined in stereomicroscope. The highest and lowest values of leaf morphometry were, respectively, 118 and 67 mm for total leaf length, 51 and 34 mm for maximum width, 78 and 42 mm for length from the base until the maximum width, 16 and 10 mm for petiole length, 2.3 and 2 mm for total length on maximum width, and 0.65 and 0.6 for length from the base until the maximum width on total leaf length. In regards to leaf venation, differences between leaves of different origins were not observed, which presented pinnate primary venation; semicraspedodromous secondary venation, alternate percurrent and sinuous tertiary venation, regular polygonal reticulate quaternary venation and dichotomizing 5tha vein category
O presente trabalho objetivou analisar a morfologia foliar (morfometria e nervação foliar) de procedências de erva-mate coletadas no Sul do Brasil e Argentina. Analisaram-se 30 folhas de cada procedência, obtendo-se cinco medidas (comprimento total da folha, largura máxima, comprimento desde a base até a largura máxima, comprimento do pecíolo e área) e calculando-se dois índices (comprimento total sobre a largura máxima e comprimento desde a base até a largura máxima sobre o comprimento total da folha). Para a nervação foliar, as folhas foram clarificadas por meio da técnica de diafanização. Os maiores e menores valores morfométricos foram, respectivamente, 118 e 67 mm para comprimento da folha, 51 e 34 mm para largura máxima, 78 e 42 mm para comprimento desde a base até a largura máxima, 16 e 10 mm para comprimento do pecíolo, 2,3 e 2 mm para comprimento sobre largura máxima e 0,65 e 0,6 para comprimento desde a base até a largura máxima sobre o comprimento da folha. Quanto à nervação foliar, não foram observadas diferenças entre as folhas das distintas procedências, as quais apresentaram nervação primária penada, nervação secundária semicraspedódroma, nervuras terciárias com percurso alternado e sinuoso, nervação quaternária reticulada, constituída por polígonos regulares e nervação de 5ª ordem dicotomizante
RESUMO
The present research aimed to evaluate the foliar morphology (morphometry and leaf venation) of origins of maté collected in southern Brazil and Argentina. For the study of the morphometry, thirty leaves/plant were analyzed, and five measurements (leaf total length, maximum width, length from the base until maximum width, area and petiole length) and two indices were obtained (total leaf length on maximum width and length from basis until maximum width on total leaf length). The leaves were clarified by the clarification technique and examined in stereomicroscope. The highest and lowest values of leaf morphometry were, respectively, 118 and 67 mm for total leaf length, 51 and 34 mm for maximum width, 78 and 42 mm for length from the base until the maximum width, 16 and 10 mm for petiole length, 2.3 and 2 mm for total length on maximum width, and 0.65 and 0.6 for length from the base until the maximum width on total leaf length. In regards to leaf venation, differences between leaves of different origins were not observed, which presented pinnate primary venation; semicraspedodromous secondary venation, alternate percurrent and sinuous tertiary venation, regular polygonal reticulate quaternary venation and dichotomizing 5tha vein category
O presente trabalho objetivou analisar a morfologia foliar (morfometria e nervação foliar) de procedências de erva-mate coletadas no Sul do Brasil e Argentina. Analisaram-se 30 folhas de cada procedência, obtendo-se cinco medidas (comprimento total da folha, largura máxima, comprimento desde a base até a largura máxima, comprimento do pecíolo e área) e calculando-se dois índices (comprimento total sobre a largura máxima e comprimento desde a base até a largura máxima sobre o comprimento total da folha). Para a nervação foliar, as folhas foram clarificadas por meio da técnica de diafanização. Os maiores e menores valores morfométricos foram, respectivamente, 118 e 67 mm para comprimento da folha, 51 e 34 mm para largura máxima, 78 e 42 mm para comprimento desde a base até a largura máxima, 16 e 10 mm para comprimento do pecíolo, 2,3 e 2 mm para comprimento sobre largura máxima e 0,65 e 0,6 para comprimento desde a base até a largura máxima sobre o comprimento da folha. Quanto à nervação foliar, não foram observadas diferenças entre as folhas das distintas procedências, as quais apresentaram nervação primária penada, nervação secundária semicraspedódroma, nervuras terciárias com percurso alternado e sinuoso, nervação quaternária reticulada, constituída por polígonos regulares e nervação de 5ª ordem dicotomizante